Routers - Small Business

I purchased the RV180 to replace a dead Linksys BEFVP41 to connect a home office to HQ.  The Linksys was configured with three IPSEC tunnels to connect to three different subnets all through the main HQ gateway.  Note that each tunnel is independent ...

I have configured PPTP Server on RV042, and created 3 accounts. I am able to connect from Windows PC without any problems.In the router's logging utility, there doesn't appear to be any log entries indicating either successful or failed attempts to c...

Our VOIP phones are having problems with the RV042/RV942G. This occurs with RV042 running OS other then 4.0 and all RV042G (they run OS 4.2). What happnes is that one extention cannnot reach the other. I have been informed that this is a SIP issue, a...

We connected to locations to the RV042 by setting up 2 Gateway - to - Gateway VPNs - both locations can communicate with the RV042 and devices within the local LAN of the RV042 - however at the moment it is not possible to send traffic from 1st VPN L...

Good day,currently I experience some connectivity problems on a RV082. The latest Firmware is installed (no V3 unfortunately).Currently the router is pingable and also Port 80 and 8080 are open but they do not respond to any http request. Routing fun...

My current network consists of 4 computers, 3 windows 7, 1 Windows Home Server 2003. All are wired to a gigabit unmanaged switch which is connected to a Netgear WNR200V2 router.  The router is connected to the cable modem. I replaced the Netgear WNR2...

I've got a WRVS4400N V2 Router that just keeps rebooting itself. It powers up, the diag red LED stays lit, it gets part way through the boot process and reboots itself. I would like to try to reflash the device, but don't know if this is possible in ...

I'm setting up a site-to-site VPN with an RV082 ( and an RV042).The RV042 is behind an Actiontec modem/router that has the local public IP address.So, this address is registered with dyndns so we can find it with a name.The name is entered into the R...

Have the Cisco RV016. One single internet access on WAN1. LAN1 connected to a 24-port ethernet switch. Connected to LAN8 is our customer wifi access unit. To separate the public wifi, I set LAN8 to VLAN2. LAN1 is set to VLAN1. How can I set this rout...

i tryed to update my rv120w from 1.0.2.6 to 1.0.4.10 after about 15 minutes i power cycled the router.it now has alternating green power and wireless lignts flashing and router is unresponsive.it does not give out ip address and not reachable when se...

Hello,could anybody explain what does this log message mean? (RV120W fw 1.0.3.10)2012-05-14    19:59:26    warning    HERMES    kern    KERNEL    [Kernel] ERROR:endChantRecv: protocol PNAC returned !OK2012-05-14    19:59:26    warning    HERMES    ke...

Hello,I have some errors in the RV220w log files, and i dont know the reason of these errorsMon Mar 26 19:59:48 2012(GMT+0100) [rv220w][System][PLATFORM] /pfrm2.0/bin/bwLimitConfig /tmp/system.db 18 dot11STA 2 failed. status=-1 Mon Mar 26 19:59:48 20...

We have just buy a Cisco Small Business Router, model RV082. I need to enable the content filtering, but we just realized that this equipment does not filter HTTPS urls, even with the solution "Cisco ProtectLink Web" the equipment does not filter HTT...