Switches - Small Business

I just purchased two sg350xg-2f10 switches. They are working fine for the most part, but the configuration only appears to show 8 LAG groups. The data sheet shows " ●  Up to 32 groups ●  Up to 8 ports per group with 16 candidate ports for each (dynam...

Hi, I am trying to get VLAN information from an SG500 switch, basically the VLANs each port carry in trunk mode and the VLAN id for access ports. I found some entires for VLAN under .1.3.6.1.4.1.9.6.1.101.48 using  CISCOSB-vlan-MIB.  Basically it ex...

Hello, Could you help me to block websites like youtube and facebook on Cisco 891F router for the whole network. Thank you.

I have a SG 200-50 50-Port Gigabit Smart Switch on a site. It is connected to a modem/router by Cat 6 Cable and other devices connected to it in rest of the port. The DHCP/DNS is handled by modem/router. Everything is working fine. Last week the net...

After upgrading from 1.3.7.18 to 1.4.2.4, the Switch stopped forwarding on all ports. Rebooting the switch helped, but nothing in the logs. We switched back to 1.3.7.18, and it works again as it was before. Any issues known with 1.4.2.4?

Morning All We're having a few issues after replacing our HP switch with a stack of SG500X switches. What we are seeing is that all is working fine apart from when we receive a new phone or delete a MAC address of an existing phone from the Windows ...

My problem is that the switch all of the sudden doesn't boot up anymore. The System LED constantly flashes, after probably 40-50 seconds or so it constantly lights for a second, afterwards all the lights on the ethernet ports light up for a second an...

We are currently having a problem with our high availability environment whereby the cluster loses quorum and all the VMs reboot when the CISCO master is power cycled.  The relevant components in the environment are shown in the attached PDF file.  ...

Hi, I am trying to get VLAN information from an SG500 switch, basically the VLANs each port carry in trunk mode and the VLAN id for access ports. I found some entires for VLAN under .1.3.6.1.4.1.9.6.1.101.48 using  CISCOSB-vlan-MIB.  Basically it ex...

The SG300-10 powers up, cannot reach web interface.  Console connection will not start.  All ports are flashing power light is off.  I cannot reboot with reset, or factory reset. Any suggestions.

Hi, I am texting this discussion 2nd time.  Still waiting for the assistance in this case. 

I have a PC with 2 NICs in it.  One has all of the normal Stuff, the 2nd NIC has nothing checked in its Properties.  2nd NIC is connected to an SG300-52 Switch setup as General Access, untagged VLAN 101. No RMON/Port Mirroring or anything special. On...

Hi, looking for some help with output drops.  2 stacked 2960x switches were installed Feb 2016.  In that 2 month period some ports are showing tens of thousands of output drops.  The 2-link port-channel trunk is gigabit and has 188k output drops.  Ac...