Software-Defined Access (SD-Access)

Hi,I'm looking for Cisco-DNAC-MIB to download, I just found mib browsing reference at :https://mibs.observium.org/mib/CISCO-DNAC-MIB/But the mib is nowhere to be found, is this browser actually true to mib's existence or just a made up explanation.

I'm trying to apply SGACLs to do micro-segmentation in SD-Access.Right now I have 2 ports with statically assigned SGTs, one is "Employees" and one is "Guests", both in the same VN (subnet).I have a Policy created in DNA-C that says SGT "Guests" to "...

Hi All,we recently moved our infrastructure to SD-Access interconnecting three sites via a pre-existing MPLS network using IP-Based Transit. Now we are planning to interconnect new sites and we are evaluating to use SD-Access transit or SD-WAN Transi...

Hi All, the environment is just using DNAC with template editor to setup the catalyst switches and doing some assurance. I would like to ask, using the template editor can do everything to the switches like you are just configuring via CLI? Can it do...

HiNo Idea why these messages have started no changes have been made to the switch config, does anyone have any ideas pleasesessmgrd :   failed for clientSESSION_MGR=5=FAIL Authc fail. Authc failure reason : Cred Fail no changes made on switch Thanks 

Hi all,I have a situation where I have configured MAB for a specific endpoint. Even though the device authenticates with MAB, we also get the following logs on our switch.027552: Nov 15 10:12:15.245: %DOT1X-5-FAIL: Switch 1 R0/0: sessmgrd: Authentica...

Hi, I am new in SDA, I would like to know how and where should I connect my TC nodes physically? Can I connect it physically in my FiaB node or it should be connected at my shared services network? thanks

We are replacing Viptela 100B with ISR1100X and I wanted to go to all Cisco IOS on our edge routers.      I am currently running 17.05.01 on the 1100X devices we have.    I just received 6 ISR1100X with Viptela code loaded and was going to switch to ...

In reviewing Border Node selection for SD Access Transit (LISP Pub/Sub), the Affinity-ID feature determines the BN selection using the lowest value of Affinity-ID.  Evaluating these values in the following manner determines the border node selected. ...