Storage Networking

Hello,We have setup Call home already on our MDS and it is working perfect, but I want that this X-bar error gets also reported in Call Home.What i have to do that the following event on a MDS 9513 are send out via Call Home to EMC or my email addres...

Hi,We have this c5548p switch working for a while. Then recently it started rebooting itself frequently and finally going to loader prompt. Does any one know how to boot using tftp server from the loader prompt? I tried but said file not found. The s...

Hi,i'm trying to configure a virtual call recording  solution. I want to use ERSPAN to send the traffic from the phones to  the recording system on a Virtual Machine. The virtual infrastructure  has a Nexus 1010 installed. I'm folloing the administra...

I just completed the install of Fabric Manager 5.0(7) successfully.For some reason, when I type in the IP address from IE browser (at a different host) to install the new version of Device Manager 5.0(7). it returns with the installation for 4.1(3a)....

Any ideas how to NOT USE errdisable or allow the FCoE switch to put a port / interface / VFC  into an error disabled state?I do not see any command(s) to NOT use this feature.thanksmatt

I have a client that uses a very old mainframe that can only take ESCON.  Obviously I would like to use a modern director storage platform, and I am looking for a device that can bridge ESCON to FICON.  Has anyone heard of such a thing? Recommendatio...

Hello,We resently changed ISCSI NIC's on all servers to jumbo fames 9014 and flow control (generate and Rx).  Then programed C3750 identical as listed in document link below setting system MTU and flow control.  I have provided output from C3750 show...

Hi, Recently, I came across the interesting case, I could see the Rx and Tx power is N/A and and I have flogoi session established on that port.. I just wanted to know, does Rx and TX has nay relation with Flogi or connection between HBA and Switch p...

I'd like to upgrade the OS on our W2k3 to W2K8 64-bit via virtual machine. First, is it possible to run Cisco Fabric and Device Manager under VM 2K8 64-bit? Has there been any issues reported running these tools, on VM? Thanks

Hey Guys and Gals, I need to set up alerting for discards on certain ports in two 9509's. Does anyone know if this can be done? Is there a mib for it? If there is where do I start? Thanks for your help, JF