We are running backups over the SAN. Several client hosts HBA's are connected via the SAN to the an HBA on the backup server. All HBA's are assigned IP addresses. All hosts are Solaris 10. The HBA's are Emulex LP9002 with 6.01f driver and 3.92a3 ...
Hi All,We´ve receiving an Errormessage "An error was detected on device \Device\Harddisk5\DR9 during a paging operation."This message occures when one clusternode is up and the second comes online,too. Cisco-iSCSI-Driver is 4.1.2 and SN5428-2 is 3.5....
Does it make sense (and/or give any additional benefits) to use single cisco-tac alert group instead of combination of system, environmental, inventory and so on alert groups for internal support team notification? Worth to add that we don't use Auto...
Good morning all,We are trying to connect a Brocade 12K (PID 1) to an MDS (Interop mode 3).We can see the switches exchange ELP - RDI successfully, but we fail when we get to a zone merge.We have tried disabling or deactivating zonesets on both switc...
hi there,sorry prob a really dumb question but...We have 2x 9509 switches here and i'm trying to get the events working. If i look at the events log it tells me "Event logs not found". Is there something i need to configure on the switches to turn e...
hitrying to summary statistics under device manager (2.1.1a)result following error message failed to open summary logs (you must check summary log )how can i fix this problem ?thanksJYP
Hello ! Someone knows if SANTap could be used in conjunction with a replication appliance to obtain a LUN mirroring, much like something provided by SW Logical Volume Managers ?Thx a lot
I am new to storage networking. I wish to connect a small Hitachi SAN to a few (no more than 4) Windows and Linux servers via fiber channel, and about a dozen other Windows and Linux servers over iSCSI. I will also want to do async replication across...
I notice a new release has been posted, which I assume is just a rebuild to fix a few of the recent security vulnerabilities. Be nice to have some release notes to confirm that though...
Hello,A customer has two sites and needs replication between these two sites. They bought two Cisco Routers 7401ASR with PA-FC-1G for connectivity between the sites (using FCIP) - This PA has one 1G PC port!Now, on one site they have a MDS 9120 SAN S...
hiare they any way for ouptut interpreter on CCOworks for MDS sho tech ?should pretty useful to check config and potentialissue thanks for any comments from Cisco guys JYP
