Switches - Small Business

Hi,i try to configure the small business switches, like SGE2000, to operate with Radius Authentication for admin login purposes.I configured MS NPS/IAS under the same prerequisites like authenticating Cisco Enterprise Switches, but it doesn't work.Do...

Hi Can you advise if the SG550XG-8F8T-K9-NA can be stacked with theSG500X-48-k9-NA? The documentation available speaks to stacking of the SG500XG-8F8T-NA stacking with SG500X-48-K9, however since SG500XG-8F8T-NA  is now end of sale and has been repla...

Hi, How to enter in psbl mode is ESC send dosn't work? The psbl cursor appears, but I can not enter the sending ESC. In this case, it does not appear in the text .... Press ESC. Thank you! Tony "PSPBoot1.4 rev: 1.4.0.6(c) Copyright 2002-2008 Tex...

Hi, I'm trying to monitor memory utilization via SNMP on an SG200. I've downloaded the Small Business MIBs and used them to walk the SMMP tree on the switch, but I cannot find an OID for memory. I found the ones for CPU, and lots of other stuff, but ...

Hi Guys, Help needed, as I am encountered a problem and I would like discuss it with all experts here. As shown in the network diagram attached, some inforamtion about the network as below: 1. All the VLAN gateway is on Core Switch 2. The Core Switch...

HI, i am using above mention switches and i have created my network using 10.0.0.1 subnet 255.0.0.0 created ip pools and assigned to users as per pool on port 1, i have connected router and gave this router IP 10.0.2.1 and subnet 255.0.0.0 i am con...

Hello, I have two subnets in my office as below, 192.168.1.0/24 192.168.2.0/24 I need all the systems should communicate with each other. There are 4 switches of 48 Port and all are uplicked with each other. I just found that I can create VLAN routin...

HI, This is the running config for sg300 switcha86a4c#sh running-config config-file-headerswitcha86a4cv1.3.0.62 / R750_NIK_1_3_647_260CLI v1.0set system mode switch file SSD indicator encrypted@ssd-control-startssd configssd file passphrase control u...

I got my first 4948 switch.  I configured my management port Switch>show ip interface brief Interface                  IP-Address             OK?           Method          Status              ProtocolVlan1                       unassigned            ...

Hello! I have a SF220-48 smart switch which documented as support both port-based vlan and 802.1q vlan,  but while logging into the web admin page, I cannot find how to setup up the port-based vlan. Will someone help me on this or this device simpl...

i have an sg300 and and sg500, each running 1.4.0.88.  i want to setup raduis vlan assignment, and seem to be having some issues.  my radius server will reply with the attribute/value pairs to set the port to a vlan, but i think i am missing somethin...

Hello Experts, I am facing a problem we have 2 SF300 switches, they are connected by SFP module. we can ping from one end to another end  through PC. But my client have a software (type of Monitoring) on a PC its connected on SW1 and the SW2 have so...