Switches - Small Business

Hi,With the new migration to Energywise switches (and others) I was wondering if the upgrade of IOS in a 2960 for example to get the Energywise Compliance is a free upgrade, or does the end user  have to have a SmartNet software contract?Thanks in ad...

I just got a 2008MP and I need to "chain" it from my 4506 which is supplying PoE for our phones.  The phone is getting power but it's not communicating...  Any assistance for things to look for?

Hi,pls suggest Linksys 10/100 managed switch which can support single mode and also mention part no. of Linksys single module.Thanks & Regards

HiI just put a nice SRW2048 into our network but can't seem to get Webview running on Safari or Firefox on OSX Leopard. Is this a common problem? Is there a fix? I can access it fine using Internet Explorer under Parallels, but would really prefer Sa...

Im having SRW2048, when i used to copy files between computers it took long time to done.What step should be taken to overcome this issue ?

     my srw2024 stops responding and all LEDs starts glowing, after power cycling it comes back to normal state.see the logs attached.   

I'm unable to correctly set the time on a h/w version 3, firmware version 1.01 SLM2024 switch. After attempting to do so, the unit is set to an arbitrary date/time such as 01-02-00 @ 11:19:19 (the current date/time on my unit). Attempts to correct th...

Hello, we have 3 SRW224G4P, we configure them and they work fine. As soon as there is a power failure they all loose some settings and retain others. I'm lost.Information lost includes IP address, VLANS, and VLAN settings for ports however if a port ...

In my offiec i want to connect 8 accesspoints and 8 smart boad and 8 pcs to a switch the access points are cisco 1240g series and controlled by a wlan controller.this switch should be connected to a core switch 4507 using fiber.can i use these esw sw...

We have recently switched to Linksys (now Cisco) managed switches.  The problem is this: I can only seem to get to the switches (via Webview) if I am on a pc that is on the same switch or hub that the managed switch is on!  So, I have gone into the w...

How can we activate the fiber connectivity? by default this is not activated...

I have a SRW224G4. I can create multiple VLAN's but when I try to create another vlan interface and add an ip address to it, I get the error message "ip address table overflow". Is this switch limited to having only 1 IP address? I would like to have...

hi,I have several SRW244 switches. It has been a while and I cannot find all of the ip adresses.Is there a way to scan the netwerk and find the switch to change the ip adress?I've tried the  Cisco network Assistant, but no luck there...

Hello,I'm looking to purchase a Cisco SGE2010P 48-port Gigabit Switch (POE) for a 100% Macintosh environment. Because of this, none of the machines will be able to access the switch (including initial, out of the box setup) via the console port. So, ...