Switches - Small Business

Good Day Everyone,Support Request: SR636256465 I have a problem with mythical radius and 802.1x support on a brand new SG200-26 Info as follows :Firmware Version:1.4.1.3Firmware MD5 Checksum:a325fec192ba4927b6809c1867a22278Boot Version:1.3.5.06Boot M...

Hi All,I have here a Cisco SG200 - 26P switch..i'm experiencing intermittent ping between VLANs ...host A in vlan 303, host B vlan 319, host C in vlan 319.intermittent  ping from host A to host Bping ok Host B to host C. Is there anyway to resolve th...

 %BNJR-N-OVERFLW: BonjourP_process_domain_name 10: Input domain name overflow occurred  Anyone know what this is?

Hi guys, I have an old Linksys Business SRW224G4P  ( not the new Cisco version ), and it was working so far since 2009. Now, i had a problem with it and the firmware was gone from it. Probably some flash memory problem. So, i got it up again uploadin...

hola como estan mi pregunta es que como hago para conectar el switch catalys 3850 con un catalys 2960x mediante fibra oprtica.ya configure los dos switch y cuando conecto los puertos del switch 2960x no encienden mientras que si lo conecto con un SG3...

Hi All,I have here a Cisco SG200 - 26P switch..i'm experiencing intermittent ping between VLANs ...host A in vlan 303, host B vlan 319, host C in vlan 319.intermittent  ping from host A to host Bping ok Host B to host C. Is there anyway to resolve th...

SG200-08 and SG200-08P fail to hold or update Date/Time(New installation for a UC320 setup.)I've got both an SG200-08 and SG200-08P that are failing to maintain date/time when set with "Use Local Settings".  Every restart/powercycle causes them to re...

HiIf I need to check which ports is trunk for uplink,  which command I can use in sf-300 to verify that bcz I can't use #show interface trunk, one more thing How I know the MAC address for switch by cli, #show version not helpfulThank you

I have been trying to get an multicast distribution architecture running using the multicast tv vlan feature in an SG300-28 switch. I have followed the configuration guides and everything appears to be done properly. The receiver port shows that it i...

I need to know if there is a password recovery procedure on a switch ESW 520thanks

Hello, We have the following setup:1 SG300-52 as "core" switch (which has the uplink to our SonicWall)1 SG300-28 in another part of the building connected to the SG300-52A couple of SG300-10 in the offices with to few wall outlets - connected to eith...

Hello everybody, Everybody knows what is the output command to redirect line of commands in a file thanks to TFTP with SG300 switches. I want to do like Catalyst switches : sh vlan | redirect tftp://ip_host/filename.txt Thank you in advance.greenkev

We have recently shifted to Cisco RV325 as our primary router for office. After the installation our remote ssh connections are disconnecting after some idle time. ?  Any suggestion on how to fix it!!!