Switches - Small Business

can anyone provide 3D CAD files for IE-3400H-24T?

I have been looking the data sheets for the IE-3400H-24T and it only gives a power consumption for a range of 9 to 60 volts DC. Which is 4.6A at 9 DC down to .75A at 60VDC. Does anyone know what the power consumption would be for 24VDC?thanks

Hello Guys,  I'm encounter the following error always with one of my new cisco switch sg250 that i just configured for my LAN. I just need some help of how can i solve. Is the following error can cause any networking traffic drops or not. please help...

Dear TeamKindly check the below swicth details for the RMAModel No.   CBS350-8P-E-2GSERIAL NUMBER - PSZ27091FEY Thanks & RegardsDurgesh Sharma8988114889

Hi,I want to secure one LAN port of my CBS350-48P switch. It is located to PoE camera outside the building.It would be great to shut down the port, if another device is put into this port.How can this be solved?Best regards,Heinz

Hi,I have a problem with this configuration as of certain FW. I know version 3.1.0.17 was OK and current one 3.4.0.17 is not and unfortunately it is not possible to downgrade to confirm the issue. I am running DANTE alongside WYrestorm Network HD vid...

Trying to set up new sg350  10 p - tried using the config file from one used and working but it failed and needed factory resetmy other one has the leds turned off so have no idea what I should see ports 1 to 8 light green on left light only when usi...

Please share the warranty status of the below switches:PSZ27351CMMPSZ27351ADCPSZ27351AU1PSZ27351CCHPSZ27351ASWPSZ273519EGPSZ27351CJUPSZ27351BR2PSZ27351CQMPSZ27351CLZ

Hello All, Do the CBS350 switches support Perpetual PoE?Best Regards,Issa Abbadi

Update:Looks like there's a discrepancy from one Version of Xterm to another, the commands are interpreted differently. This can be closed, thank you very much I'm trying to configure a CBS350 24T-4X with a pre written config file, it's not the first...

Hello,I am new to networking and have been unable to pin point the source of the issue. We have two CBS 250 devices that have been acting odd lately. 2-4 times a week the management interface would disconnect for about 5-20 mins. I've compared config...

Cisco 3650 uplink to router is going into sfp port 1/1/4 and shows operational status down ?I have it set as a a trunk port on the 3650 and is connected to a 10 gb SFP port on a tp-link switch which shows it is connected The port is obviously connect...

I've recently deployed a 2x CBS350-48FP-4X stack and the CPU is pinned at 100% during production hours. There's a 2x CBS350-24FP-4X stack in the same location at the access layer with an almost identical config and that thing is fine.This problem exi...