Switches - Small Business

attempt to admin I can not save the configurationand l1_admin I do not have acces

I have a SRW2048.I have looked through the CLI and web interface and cannot find anywhere to specify a syslog server.How am I able to browse the logs or have them log somewhere?Thanks

My recently acquired SRW224G4P is now in production and seemingly working well, despite my battle with the awfully designed, awfully slow  and buggy WebView!The problem started on Sunday morning - I noticed that there was activity on the ports every ...

HiCan ESW switches be managed with CNA (Cisco Network Assistant)?  Has anyone tried this and if yes any issues/limitations?Thanks

Hi All,Just going through the ESW switches, and it looks like their is no option for 'Server' on these switches (I have noted this on the 2960G's as well).Is this a shortcoming of CCA, or has this been excluded on purpose.  I know that for the 520 an...

Hello,  I have deployed a new ESW 520 24 port with a UC520 system at a new site. The switch has been crashing periodically. Here is the error from the logs:2147474387  11-Dec-2009 14:26:49   Emergency  %SYSLOG-F-OSFATAL:   FATAL ERROR: SW2M: ABORT DA...

Hi,I have the following issue. I have around 400 pcs of srw208 linksys switches involved in a project that we must preconfigure to be deployed onsite.From what I see, the only ways to configure them is trough web interface or menu based CLI but this ...

SGE2010 firmware 3.0.0.17Seems the SGE2010 has a problem with some special characters in passwords.  I didn't test for other combinations, but if you set a password with a '+' or '&' anywere in the password, you won't be able to logon.Issue with how ...

Our SRW224G4 detailsHW ver: 00.03.00Boot ver: 1.0.2FW ver: 1.2.2bHere is a picture of our back 2 back setup. We are trying to send a time sensitive audio traffic and IP traffic over a GbE link,We assigned audio traffic (port e1) to VLAN 2 and all oth...

The SGE2010 and the SGE2000P would need a  MGBT1   1000BASE-T SFP transceiver for category 5 copper wire, support up to 100 m Need to know if this MGBT1 would work fine with a CAT 6 Cable?

Hello.My situation: I have 2 switches - SRW224G4 and SRW248G4. One of them is located on 1st floor, one of them is on the 2nd floor. Both are a part of the same network.I need to connect a device (a wireless access point) to 1 port on the switch on 1...

Hello,I am looking for a fanless switch within Ciscos Small Business switch portfolio.I did find one - 8 port PoE, but does Cisco have any other switches with more than 8-ports without fan?Regards, Hans-Petter