Switches - Small Business

Hi,Does anyone know how to update the TLS version of the switch?

First let me say that I am familiar with VLANs and Trunks using cisco CLI on Catalyst switches.I have an SG500x that I am trying to figure out.  I am able to get into the GUI.  I am trying to understand the idea of tagging and untagging certain VLANs...

Good afternoonI would like the DWG of the cisco c9500-24y4c switch if anyone can share it.Thanks in advance!

We are starting to plan around lifecycle upgrade/replacement of CBS350 in the core/distribution to a C1300 based switch (or pair of stacked 1300) based on the EOL noticehttps://www.cisco.com/c/en/us/products/collateral/switches/business-350-series-ma...

Hi,have here a couple of SG550XG and want to configure VLAN one-to-one mapping for a LAG.Problem: on the other side (Router), the packet arrived without remapping, according to the trace.Win ping - LAG VLAN2102 ---> SG550XG - PO15 - VLAN2102 one-to-o...

I have and SG350x 48P POE running 

Cisco CBS 250 | Offline for 9 minutes every 3 hours or so.We have an CBS 250 edge switch that approx every 3 to 4 hours will stop passing traffic for about 9 minutes.After nine minutes it will start passing traffic again.No interfaces go down.  No lo...

Is it possible to recovery a lost/forgotten password without loosing the existing configuration on the switch!?!? Help 

Cisco Business 350 Series switch not working not powering on.

I want to check warranty status of this serial number--F0C27523EJS ---F0C273101A2

Hi, have a CBS 350 stack and issues with the Mac based authentication, 802.1x authentication with our Radius server works fine. According to the trace, the Radius server receives (in case of a Mac) no packet from the switch. Are there any restriction...

Whatever I put for the Radius server ip the switch always show a log message with wrong server ip 0.0.0.0. Checking the log I can see this message.Debug message: "Radius server is set to ip 0.0.0.0 port 1812 key 'testing123' priority 65535 timeout 10...

Hi,Guys I have a CBS350-48P that will not boot properly. It gets to Loading system/images/active-image and hangs.I have tried to XMODEM the firmware to it, but the transfer long times after compelet transfer  !!! Failed to read FPGA (0x11) Board id r...

I am struggling to give IP address to the VLAN created (CBS350-24T-4G) . When I gave IP to the vlan the communication stops and required a reboot ti restore the same with the default IP i.e. 192.168.1.254.PS: Is it required to uncheck the IPv4 Routin...