Hi all,I have a following situation where I need to connect a user location to two data centers(primary and secondary) and extend around 15 VLANs to both data centers for redundancy.The connection to the primary data center is already configured and ...
Forum Posts
Resolved! Mangement interface g0/0 isolation
Hello guys-I have a perimeter c9300 24p switch- it has a management interface g0/0 at back panel its assigned to mgmt-vrf.I want to remove the int g0/0 from mgmt-VRF and assign it to a specific vlan- because its the perimeter switch connected to ISP ...
Hi Team, I would like to add email to get all kind of alert notification for Cisco switches through putty .please help on this
Resolved! How to downgrade IOS image
I hope I am in the right forum. I just upgraded the IOS on my 2960 and need to downgrade back to a older IOS images. I did a overwrite when I did the upgrade "archive download-sw /overwrite /reload tftp://tftp_server_ip/file_name". Does anyone know h...
I need to find some switches that meet the requirements for the company's new project, but there is a special requirement that I cannot find, which is the requirement that the switch has a completely separate mechanism between switch mode and operati...
Hi,I have situation, need to replace existing cisco nexus switches with different models , VPc`ed and VXLAN fabric My question, as soon as we replace the switch because of compatibility issues VPC never forms because of different models am look...
Hi Everyone, We have a couple of Cisco C9200L-48PL-4X as our edge switches, and we found out that whenever we try to save configs, master switch in stack crashes/reboots except for the "standby' switch. We notice this happening only on stacked switch...
HiI have a catalyst 9300 that has inputs errors on non configured and non connected port. do you have any idea of the origin of this problem?ASW-D-9300-SERVEUR-1#sh int te2/1/7TenGigabitEthernet2/1/7 is down, line protocol is down (notconnect)Hardw...
Hello All,I am facing some PoE issues in Cisco 9300, I wonder if anyone has experienced the same? Switch Ports Model SW Version SW Image Mode------ ----- ----- ---------- ---------- ----* 1 65 C9300-48P 17.06.03 CAT9K_IOSXE INSTALLJan 9 10:32:19.718:...
Hi friends, I am trying to find it is possible to configured stack between 2 WS-2960 and 1 C1000. Any suggestion?
Resolved! Which 9300L version
We are looking to upgrade our 9300L switch. In the cli it shows the model "9300L-48P-4X". When I go to download the software for it, there is only the options "9300L-48P-4X-A" and "9300L-48P-4X-E". Should I choose one of these, or am I just in the wr...
Hello. I need ECCN, COO and schedule #for WS-CS3850-24XSE.Cisco website is not listing this item.
I would like to know what is "RPF fail" issue when I execute "show run command" in Cisco 9200L switch. Why RPF issue is showing and how can I fix it.
Hi , This is relate to RMA SR 696503810. In the fault unit that we sent back to Cisco (sku: C9200-48P-A), there are some modules and peripherals that we are not detach or putting out yet, here is the list: PWR-C5-BLANK Config 5 Power Supply Blan...
Hi, I'm planning a upgrade on stacked switches, two C9500 high performance. It is running in bundle mode at the moment, and I want to set it up in install mode instead. I'm not very used to install mode. But I fear that if it would fail, would it wor...
