Switching

I use putty or secure CRT to login in to one switch, every 15 minutes, if no activity, it will log off, so how can we adjust to 1.5 hour idle time, so only adtrer 1.5 h no activity, the session will become inactive, for example in 2960 switch, how to...

I’d appreciate a recommendation for new  networking equipment to cover 4 floors including the cellar. At the moment I have the following equipment:Location - cellar rack- ISP router acting as modem (location cellar rack)- Asus RT-N16 router (router +...

Hello, theoretically, is the cisco switch (6500 family in particular) able to route packets within one L2 segment (one vlan) using default gateway instead of direct MAC? So we have computer A with MAC 00:00:00:00:00:AA, computer B with MAC 00:00:00...

HI, I am use the standard MQS to configure the QOS on the 5k FEX ports. With the access-list for RDP traffic I want to set the dscp value. It looks like from my capture on 7k, the dscp value is 0. I think either the 5k did not mark or the 7k reset t...

Hello all, Hopefully you guys can help me with an issue I am having on my network. Currently, I have 6 stack switches (3850-48P) that is connected to another switch.  When running the "CDP Neighbors" command I am able to view on the primary stack al...

Hello, one of our switches did an unscheduled reload. The device is 12 years old and sadly has an old image. vt4cat4506-16 uptime is 1 day, 16 hours, 28 minutesSystem returned to ROM by abort at PC 0x0System restarted at 22:04:28 CEST Sun Feb 19 20...

I have two remote switches:  switch A (layer 3 switch) : vlan 10 ip 10.80.1.6, vlan 20 ip : 10.80.2.6, switch port f0/1 using vlan 20 and connect to switch B port f0/2 switch B (layer 2 switch): vlan 20 ip add 10.80.2.5, port f0/2 access ports using ...

Hi,i've a stack of two 3750-G, we configured enable password to Console access, but when we connect to slave switch, we're not asked for an enable password, therefore when we connect to master switch, we need this password to access to privilege mode...

We have simple topology. R2(AS12) --- R1(AS11) --- R3(AS13) R2 and R3 advertises same route 4.4.4.0/24 to R1. R1 decides that the best route is from R2 and advertises it to R3(AS13). Everything is as expected and fine till now. But I see that R1 ad...

Looking for feedback from other organizations that have large 3750 stacks.  I've got one stack of (8) 3750's composed of (6) 3750G's and (2) plain 3750's.  This particular stack is usually unresponsive to SNMP queries and often fails to write config ...

hello ,  I have new 3850 stack added to network  we have local enable secret on the device which works fine even for remote management.  But when I add the tactics key the tactics credeteinals  takes me to user level but doesnt work on enable level ...

This document says: IA client ports do not support these features: ... - IEEE 802.1Q tunneling My ports will take the commands but I just can't seem to get it working, however I can't see anything conclusive online that says it should or shouldn't ...