Switching

Discuss Catalyst brand switches with peers and experts.
cancel
Showing results for 
Search instead for 
Did you mean: 
cancel

Labels

Forum Posts

Hello, Cisco Community!I’m really happy to share that I’ll be hosting the Cisco Community Lab Series, a brand-new hands-on learning journey designed to help you build practical networking skills step by step.Every Thursday at 8 PM EST, I’ll post a ne...

I have a 6509E with 4000 Watt power supplies that is currently in power redundancy mode = redundant. I am getting PWRDENY on module 7 which is a 6716-10GE module needing 488.46 W and there is only 441.0 W available. This module has been running witho...

Mike Mott by Level 1
  • 1015 Views
  • 1 replies
  • 0 Helpful votes

Hi, Yesterday, I realized that one of my company's client has 2 Data VLANs belonging to the same logical subnet. I mean in the subnet 192.168.100.0/24 there are hosts in VLAN 10 and hosts in VLAN 20.  How is this possible? Can this fact be the origin...

Hi all , please someone can advice me for Cisco Router to use for VPN  , we have 10 location and we would like to have VPN connection between each location , that have between 30-50 users . thank you 

I am given a topology to make with inter-vlan routing. I'm using the router on a stick method and I am given 6 sub-interfaces to make. I need to know how I can make them connect to the internet? My main router is connected from a serial port to anoth...

xray_9051 by Level 1
  • 351 Views
  • 1 replies
  • 0 Helpful votes

Hi All, We are in the process of upgrading & re-designing an existing university campus network from 1G to a mesh of 10G core backbone. The objective of the project is basically high availability & redundancy. Based on my draft diagram, end results w...

Hello Fellow Cisco Users Thank you for reading this post. This is my problem - I cannot get my multicast packets (from an IP camera) to stream across an equal cost alternate path to my PC receiver when the primary path fails. I have attached a diagr...

gohij0001 by Level 1
  • 1231 Views
  • 10 replies
  • 0 Helpful votes

Hi, I am running Version 15.5(3)M and could not reset the AP. Tried the steps recommended in documentation (pressing the reset button for 10 seconds while it is powered on). Every time, I try this, could see the IR 829 loading with its previous con...