Buy or Renew
Buy or Renew

Switching

Discuss Catalyst brand switches with peers and experts.
cancel
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Search instead for 
Did you mean: 
cancel
Start a conversation

Labels

Forum Posts

Start a conversation

C6800-16P-10G C6807-XL IOS upgrade

Hi, I'm working for a customer who asked me to check why their C6800-16P-10G wasn't working as expected. They're running 15.1(2)SY4a which doesn't meet the minimum required release: 15.2(1)SY. Which IOS would be preferred? They're now running MD re...

application remote access via vpn

I have a quick question that I need clarity on, I have an application that goes and check for the proxy server settings on client file to be able to connect to an external server(Service Provider). The users can connect to the service provider server...

thabisom1 by • Level 1
  • 289 Views
  • 1 replies
  • 0 Helpful votes

Wireless Router off of ASA 5505

Greetings all, first time poster here. I am "alright" with Cisco config but I need in knowing if I can do the following: We have ASA 5505s. Sec+ license, VPNs connecting the ASAs- branch offices. DHCP and DNS for the network are both served up by a W...

Resolved! 891 VLAN Routing Assistance

OK guys, well I am back again to bask in the pool of your infinite knowledge.  I am working with an 891w trying to get some simple routing done.  I am no genius with it, and right now am more harm than good.  I have 2 vlans, the default (1) and then ...

Resolved! Spanning Tree Blocking Port

Hi all, please see the attached.  SW0 has lower bridge ID than SW1, but SW0 fa0/1 port is in blocking mode. Why? Isn't lower is better ? SW3 is root bridge. SW O 33342Mac : 0002.4AC7.115A SW1 33342Mac: 00D0.97D7.58A0

Resolved! ACL problem to a specific network

hello, I'm implementing ACL's on my company's , but I came across a problem. I want to filter the protocols that go to the network of printers, allowing only PING, 9100, 161 (snmp) and web access only to a specific network. Everything works except ...

Can't reset Cisco SRW2024p

Hi, i have a cisco SRW2024p and I can not access to the web interface and not responds to a ping. I tried the procedure for resetting via putty console, 1. Connect to the console port using terminal emulation parameters (typically 38400, 8, 0, 1, Non...

VRRP on loopback

Hi, So I'm trying to configure VRRP on two CISCO 3850s (not stacked), so far I have it working with a VLAN interface. But the problem I see is that the VLAN interface only comes online when a host is connected to it. So without a host the VRRP inter...

Resolved! parameter-map type urlfilter on IOS-XE

Dear all Just a quick question: Is this command and feature set available in IOS-XE 3? As far as I can see and have been told this feature has been taken out in IOS-XE cause not that many people were using it. Just would like to have a brief confi...

Load more