Looking for help with configuring PACL on ws-4506 switch. Successful with configuring ip access-list extended - name - in but unable to configure ip access-group - name - in on switchport interface. I can configure PACL on a 3750 and a 4507's without...
I'm trying to get a trunk working between my 3760 switch and an HP 1810-8G switch. I understand after reading the posts below that "trunking" for HP is akin to an etherchannel on the Cisco side of things, I don't want that. I want a link that carries...
Is it possible to handle via a local IP DHCP configuration on a 3560 switch any DHCP option e.g. #242 with the necessary information(s) in a string (like 'MCIPADD=192.168...etc.')?
I am running a 4510 with a SUP-8. I am trying to implement 802.1x for NAC, but the switch refuses the interface-level command. Below is the entire config I am trying to implement and the results. Any ideas as to why it rejects the interface level com...
Hi all, We have a 1710 router with 2 Ethernet ports (1 Ethernet and 1 FastEtherent) and we are configuring one or two vlans, and I am just unsure of myself of the proper configuration1 - When the VLANs are configured do we need or have to have access...
Hello,I have just upgraded 2 3750 switches in a stack via the master and reloaded the master switch remotely, how can I reload the 2nd (member) switch?Regards
Hi, I have a working configuration for PBR on a 6500 running 12.2.33SXH8b. PBR is applied to an SVI interface. Like I said, PBR works exactly as I want it to. The thing is when I start adding more traffic to the PBR (only 3 route-map classes) at som...
I am having issue with upgrading the IPbase 4500X to VSS. I like to know how to remove all the VSS configurations and reset the switches by to factory default.I had many issue configuring vss on 4500X with different license (ipbase, Enterprise). than...
I have a network where I have created 4 different VLAN's. One VLAN for phones which is tagged and then several other VLAN's that are untagged. I would like to route these together using a CISCO layer 3 switch. I have tried doing this but when rout...
Hi all, I have to configre hsrp authentication in a 7700 series, I do the following command. interface vlan 10hsrp 0 ipv4authentication md5 key-chain Set key chain key-string Set key string Which one should I use to encrytp my password?
Hi all, I have to configre hsrp authentication in a 7700 series, I do the following command. interface vlan 10hsrp 0 ipv4authentication md5 key-chain Set key chain key-string Set key string Which one should I use to encrytp my password? thanks.
I have a C3850-NM-4-1G 48port switch with a Cisco Ethernet SX Mini-GBIC SFP Transceiver (#MGBSX1) installed sitting in our rack. 600 feet away in a different cabinet I have a Cisco Catalyst 3750 with the exact same transceiver installed. I am running...
I purchased a Nexus 3172PQ online secondhand and when I received the switch the admin module (the module with the two rj45 ports and the usb) on the right rear of the switch was missing. I contacted my seller and they said they would send one to me o...
