Switching

Hi all, I have to connect via L2 a 6509 with a nexus 7700 series, regarding the Spanning tree configuration what will the best practices be for this integration? Thanks. 140

Hi  I have new 8 switches ( 2960S-48 FPD-L )  in my network some of them not powering my access point (linkysys LAPN300) & ip camera when i plug the cable to onther ports from 25 to port 48 it is working then i test all port from 1 to 48 and the resu...

Hello:I have a router 2901 with an EHWIC-4ESG module installed. The switch module is working fine, I created several SVI and Intervlan communication is working, however, I can not get any host in my internal VLANs to communicate outside the router, n...

Hello, I have a Cisco router 3800 and i am trying to use it for our Guest WiFi Internet Access the installation is as shown within attached image I am trying to use this oruter for clients with IPs 192.168.103.0/24 to access the internet. I trie...

Hi  I have done the configuration for syslogs but not getting the logs in buffer Device model:- WS-C2924M-XL IOS:- 12.0 Please help is there any IOS bug ?

Hello.         We have a cisco 3750,  ip routing enabled, service dhcp (enabled), 2 vlans: vlan1=LAN, VLAN 202=cisco Phones. I need the phones to get ip addressing with dhcp. Routing is ok, If static address is configured,  two points from each vlan...

We are facing intermittent issue of network service loss, approx. once or twice a week. We experience what appears to be a port flapping issue, which then triggers a series of failovers between switches on the network, which results in users losing i...

Hello, I work for a customer who needs the network must be up all the time. They have two 3750 switchs that act at the core network level. They want to create a stack with these two switchs. These two switches deliver trunks for access switches. We h...

Two Nexus 5596 are vPC peers and vPC is up and successful. Upstream is Nexus 7k  Between 5k and 7k there is double sided vPC, meshed ethernet 10G connections. Now  One HP C7000 servers connect to Nexus 5k HP C7000 has two fabric , Fabric A (4 Nic) ...

Hello All, i have one Question, i have Nortel SW with SFP "GE SX/1000 SX" if i take this SFP and connected in Cisco Sw 2960-X, will work OR NOT ?? Regards,

Hi all, I have 2 x 2960x stacked togethter. Switch 1 is master Switch 2 is member. There are no addtional configurations done to configure the switch priority etc. The election is done without manual intervention/configuration. ===================...

even though a router connected to an access port on a SG300 switch the RSTP disables the port.How can i fix this?