Switching

Good Morning All, Am currently looking into high cpu figures on one of our 3850 switches the model is WS-C3850-24P running  03.02.03.SE. we had an alert through for a sustained period of high cpu usage, upon investigation we observed the following. ...

7206#show verCisco IOS Software, 7200 Software (C7200P-ADVENTERPRISEK9-M), Version 12.2(33)SRC, RELEASE SOFTWARE (fc3)Technical Support: http://www.cisco.com/techsupportCopyright (c) 1986-2008 by Cisco Systems, Inc.Compiled Fri 11-Jan-08 02:44 by pro...

Hi CSC,I have a query regarding default routes in EIGRP. I have two routers, lets say RouterA and RouterB that are EIGRP neighbours.RouterA has a static default route pointing to my ASARouterB has a static default route pointing to RouterA. Looking a...

hi  i have installed an HWIC-4ESW on a cisco 1841 router and attached an ADSL modem to one of its ports. (f0/0/0)i have created a vlan and put the interface on that vlan and assigned an ip address to the interface vlan.now i can ping the ADSL modem.t...

Unable to telenet onto a cisco 3750 stack of 4how resolve this without rebooting the stacktried using the snmp tool still does not workplease advise accordingly Unable to ssh to the stackeven while using a console cable still unable to access any of ...

Hello communityI think I understand something completely wrong and therefore it is not working as I did.I have three layer3-switches (SG300-28P) all connected to a Catalyst switch (3750X). These switches are all connected via trunk connection to the ...

Hi,I have two RV042 Dual WAN router. The current IP Address range is 192.168.100.1 - 192.168.103.254 / 22. We have extended LAN, 500 IP's in one premises in another 500 in another premises, but all are in the same subnet. Both premises are connected ...

I have questions as this my first enterprise level cisco router 1941.  I purchased it orginally due to the intigrated security features such as the ability to span ports and run a sniffer as well as some of the other features.  However I realized aft...

The Switch 2960X support limited layer 3 features as static routing, if has the capability to read layer 3 and route packets, then should be recognized as a Basic Layer 3 switch?The configuration guide says that it could support static routing and de...

Hello everyone,        Could IPv4 PBR feature deploly on Nexus 3548P switch ? I configured PBR feature on my 3548P switch , but it did not work as expect as on IOS platform  , the configuration present to you as follow, the special packet flows can n...

Hi All,I had an issue where the multicast streams being published took over 4mins to recover when an HSRP failover occured.Now I know PIM is independent of HSRP and that the multicast streams were being forwarded by the standby router, so the dropof ...

Hi everyone! I'm configuring a Cat4500 with IOS XE 3.5 and the command  "switchport trunk encapsulation dot1q" it's being rejected, apparently the command " switchport trunk encapsulation" is not supported, but I have being looking in the Configurati...