Switching

Discuss Catalyst brand switches with peers and experts.
cancel
Showing results for 
Search instead for 
Did you mean: 
cancel

Labels

Forum Posts

Hi, I'm planning a upgrade on stacked switches, two C9500 high performance. It is running in bundle mode at the moment, and I want to set it up in install mode instead. I'm not very used to install mode. But I fear that if it would fail, would it wor...

Hello, I have a new Catalyst C1000-24T-4G-L, running 15.2-7. I cannot seem to get the switch back into the mode where I can access the Web GUI/Configuration Wizard.Out of the box I was able to utilize the Web GUI and go through the Configuration Wiza...

ChrisAG by Level 1
  • 3285 Views
  • 3 replies
  • 0 Helpful votes

      Hi,  Can i configure access ports in to port channel on Nexus 7K switch.If possible then please provide the complete configuration.....Thanks,SATHYA

sathyasav by Level 1
  • 16938 Views
  • 3 replies
  • 0 Helpful votes

We have a pair of 9148s switches that we can access via SSh but cannot for the life of us figure out how to access the GUI. The only browser that we have success even seeing the switches is Firefox (121.0.1)  and it says I need to install or Run Cisc...

Hi guys,I'm implementing NAC on my organisation's nodes and I've noticed that every time a PC goes to sleep it creates an authentication log on the switch that multiplied by various PCs connected, it fills up the log buffer with multiple lines like t...

Zakitis by Level 1
  • 1153 Views
  • 5 replies
  • 0 Helpful votes

I have a Cisco 2960S which connects to a core 4500X switch. When I first inserted fiber cables the 2960 was having a link flap issue. That was resolved by using a different sfp module. However there is now a high input error rate. Not just in the 296...

singh7881 by Level 1
  • 3377 Views
  • 15 replies
  • 0 Helpful votes