Switching

WCCP will support on WS-C2960X-48TD-L switch? If it is surely not support on WS-C2960X-48TD-L switch then I can go ahead to take 3560 switch and is it compulsory to take the ADVIPSERVICES license for this WCCP?   Can someone please confirm it?

Hi all,I have following problem: I cannot see the MAC address of a printer on a switch port that is configured as trunk port with as native VLAN the data VLAN.The printer was initially configured with an IP address from the range of the Data VLAN the...

Dear Support,I have a cisco 2900 series router with the module "SM-ES3-16-P" installed.Now the router is showing two additional internal interfaces gi 1/0(routed port)  and gi1/1(layer 2 port)  where as the module also shows two additional internal  ...

Hi All, Can someone please confirm that does Cisco 300 switch supports tacacs authorization and accounting ? or just authentication ? Kindly guide

how do I add a user with full admin rights to a 2960? is this correct? username user privilege 2 password 7 password ?

Hello,I am trying to mark dscp and cos both for certain traffic sourced from same mac address. I am trying to do this by matching source mac addresses in class map. But the policy map says that I am not allowed to set more than one thing based on a c...

Hi,does anybody know how I can run point-to-point and point-to-multipoint l2 tunnels over an ip backbone based on Cat68K without MPLS?Afaik L2TP isn't supported.I found some information about "Layer 2 over Multipoint GRE" but I cannot estimate if tha...

Hello,Recently one of our 3750 switches crushed 3  times during 2 hours with the following syslog messages:                04:21 PM             (switch-name)                  Alert      98: 00:01:39:                04:21 PM             (switch-name) ...

Could you explain  please  reason  first  ACL,log unreach.No log key  in ACL, switch has a lot of VLAN with ACL in. Packets Received by Packet QueueQueue Total 5 sec avg 1 min avg 5 min avg 1 hour avg---------------------- --------------- --------- -...

I am about to replace my distribution switches supervisor engine with VS-S720 engines. The modules came with s2t54-advipservicesk9-mz.SPA.151-2.SY2.bin image installed. I was wondering if there is a boot image compatible with this code or does the Un...

Hello all. I have a 2811 with a Cisco-installed 64MB compact flash card installed. It's not enough to install CallManager Express. We are in a pinch and need a bigger card fast. We tried using a Transcend 256MB compact flash card (not Cicso-approved ...

Hi Guys,I'm trying to implement policy based routing with ip sla tracking but can't find the  verify-availability option in our C4510R+E with SUP7-E. Is it available in 4510R switches?Thanks in Advance,Chandimal

Hello all, I have a large corporate campus that we are imminently implementing QoS on.  I would like to maintain as much of the SRND AutoQoS 4 settings as possible.  I have placed the following configs into the supervisors and it takes the config.  I...