Switching

Hi, I need to implement qos on a nexus device for a clientBasically what I am trying to implement is this but on the nexus Policy Map Enhanced_QoS_Customer_Out      Description: Enhanced QoS customers outbound Percentages    Class Cust_VoIP_Out      ...

Dear all,I have 2 Cisco Nexus 5000 with each 2 Nexus 2000 in FEX Mode. My Vlan are all in fabric mode.I would tried to connect a catalyst 3750-X and a nexus 2K together in trunk with filter vlan.NEXUS 2000 <== Port-Channel ===> Cisco 3750XN2K :Po: sw...

Help Please..Error loading "flash:c2960s-universalk9-mz.152-1.E1/c2960s-universalk9-mz.152-1.E1.bin"Interrupt within 5 seconds to abort boot process.Loading "flash:/update/c2960s-universalk9-mz.150-2.SE5/c2960s-universalk9-mz.150-2.SE5.bin"...Error l...

I am configuring the eigrp under the 3750X with IOS c3750e-universalk9-mz.150-2.SE4.bin, the 'eigrp stub connected summary' is there by default, I tried to NO it, but I could not, what is the purpose of this command by default out thereThanks

Hello,If I have the access lists configuration mention below.  As far the order of operation the router will start top to down until it finds a match.  However, let say it permits 10.87.21.155 will it stop there if it finds matches that IP address or...

                   Hi all,     Please educate me the following scenario : I have Nexus 7010 with 2 L3 modules, N7K-M132XP-12L and N7K-M148GT-11L. Now to increase more ports for end devices, I add in the module N7K-F248XP-25E and believe it's for Laye...

hi expert,we have Cisco VPN conecntrator 3000 series as this is EOS/EOL i want to move all the configuration to existing asa 5520 VPN box. Current Existing configuration on these boxes are below. I just want to know what is the capability of ASA 5520...

I have 1 stack of 3 3750X switches.BOOTLDR: C3750E Boot Loader (C3750X-HBOOT-M) Version 12.2(53r)SE1, RELEASE SOFTWARE (fc1)I have a pc attached to switch 3 port 29 (g3/0/29)interface GigabitEthernet3/0/29 switchport access vlan 900 switchport mode a...

Hi,I've have a case where the Sup card does not see the USB or the SD card.  I have a pair of switches exactly the same running the same code.  When I try on the other switch it works fine for both.Image: cat4500e-universalk9.SPA.03.04.00.SG.151-2.SG...

Hi, Here is a really basic question: i'm trying to connect to the console of a catalyst 2960-s, using a regular micro-usb cable, AND/OR a regular rj-45 with a db rs-232 converter. With the usb cable: one end in the usb port on the switch, the other e...

Hi All,I know that these two are the wiring shemes for the utp cables for connecting to rj45 connector.Actually if we connect both the ends in either T568A OR T568B, then it is called as a straight through cable.And if we connect one end as T568A an...