Switching

Discuss Catalyst brand switches with peers and experts.
cancel
Showing results for 
Search instead for 
Did you mean: 
cancel

Labels

Forum Posts

Hi AllI have a doubt related to Access-list-What would be the difference between two statement written below, as in one they have mentioned any before "eq bgp" and in second after "eq bgp": 1) access-list 131 permit tcp any any eq bgp2) access-list 1...

anil703 by Level 1
  • 1093 Views
  • 4 replies
  • 0 Helpful votes

                   Would a routed port (no switchport) do the same as the Managment port on a 3560 or 3750 in terms of security? , will the traffic to that interface be isolated from VLANs traffic on the switch.

I unplug the power, hold the mode button for over 30 seconds while powering on but the system still won't go into rommon mode.  Any ideas how to get into rommon?  Also tried some break key sequences at bootup that had no effect. System just keeps res...

netdood by Level 1
  • 6107 Views
  • 4 replies
  • 0 Helpful votes

Our 3560G-24 switch suddenly lost POE ports (with IP phones connected to them) at the same time. In the log there is this error:%ILPOWER-3-CONTROLLER_PORT_ERR: Controller port error, Interface Gi0/x: Power given, but Power Controller does not report ...

titozep99 by Level 1
  • 5275 Views
  • 11 replies
  • 0 Helpful votes

Hello,I have two Cisco devices setup to talk to each other on trunk ports. The devices are a Cisco 3560 and a Cosco 2950. I setup fastethernet 0/1 port on both to be the trunk port between the two. First I set them up both to be dynamic desireable, a...

I'm trying to bring up a redundant core server for our enclave with spare parts.  Getting error on the a newer 10GE module "power not allowed unknown card type".  According to documentation the WS-SUP720 should work.http://www.cisco.com/en/US/solutio...

I have been studying some material for the CCENT, and I came across some conceptual ideas that I cannot seem to resolve.Switches work at layer 2, right?  That means that they are concerned with MAC addresses and build tables to resolve incoming frame...

Resolved! ASA 5505 POE

I have an ASA 5505, I enable ports 6 and 7. Configured auto for speed and duplex. I cannot get the ports on.The device is AXIS T8129 PoE extender and the compliant standards are the following:IEEE 802.3af, IEEE 802.3atThe extebder should be compliant...

Hello everyone,I have a network coming up for a switch refresh.  Management is pushing for 2960s and I would like 3850s.  We are running Cisco Voice and Video over the network.  I saw a few things that seemed to be in favor of a Layer 3 switch vs. a ...