Switching

Hi,On a 2811 runningCisco IOS Software, 2800 Software (C2800NM-SPSERVICESK9-M), Version 12.4(24)T3, RELEASE SOFTWARE (fc2)I've created a vlan 50 and placed a port in that vlan. The vlan will not show up in the routing table.Usually when you create a ...

We have a problem with CDP packets on sent by our Cisco 6509's.  Unlike our other Cisco switches (4948G, 5020, etc.), the 6509 tags administrative traffic on the native vlan.  As a result the CDP packets are sent with an 802.1Q header with a tag of 1...

                   I have a 867VAE-K9. On feature navigator it is listed as supporting OSPF. However when I go into config mode and type "router ?" BGP is there, but OSPF is not. Also, under my tunnel interfaces there is no support for any OSPF comma...

Hi, I am having a strange problem with two routers showing the same behaviour. The problem is that that the routers are not reachable form the corporate LAN after some time. Pinging the routers IP is not working anymore. When the network cable is unp...

We are trying to tune CEF on a 3750 stack (4 * 3750-12S) and have hit an issue whereby the CEF commands don't change anything for the hardware forwarding path.  We have four routed Gigabit interfaces that each has an OSPF adjacency and we are learnin...

I have 2 links to 2 different departments switch with an up link of 10mb. I want to guarantee that both departments get at least 5mb, but can use part of the other 5mb that not in use. Is this possible?  ThanksSteve

Hi,I have a single DL 380 G5 server with 2 NIC , i have 2 applications which run on 2 separate WAN static ip addressesmy query is that can i install both the applications on a single server ?secondly can i assign 2 different WAN static ips on the 2 N...

In my setup , i have one core switch 4506, 3750 access switches and 4948 server switch.i have created the mngmt VLAN in every switch.the problem is i can ping the every device mngmt ip from any internal network,but my server switch mngmt ip i am not ...

I have a question,my test topology is like this.then,i have test what i want.i shutdown port-channel, both with two physical cable. and hsrp state was down, because there no broadcast domain to transfer hello packetAnd then,I was thinking, Is there a...

Hi All,I have a network setup in mind which I want to deploy.(attached network design).I have 2 WAN links, 1 x 50Mb and 1 x 4Mb (just a simple everyday internet connection).Behind each WAN link there is a firewall. Just a simple model, nothing exotic...