Switching

Hello everyone, I was looking for a way to connect an AUX port from a 1700 router to a 6500 switch module console port, to see the output of the Switch's on the 1700 router, in case there is a network downtime, I could see what's going on in the swit...

Hello community.i'm looking for a cisco 881 configuration with SDSL line as nominal and ADSL as backup.could someone of you help.Best Regards

(for example rip), then a network information is come by rip protocol to our router, what happens then?1-) Does router discard information that is brought with unenabled routing protocols on that router? or what?2-) So is it adviced that to enable al...

My group has recently started configuring traps on our switches to alert us of issues as they arise vs. waiting for the Helpdesk to receive user complaints and then responding.We have successfully configured the 2950 and 2960 switches to alert us whe...

On a 3750 you can do a show platform port-asic stats drop command.  Is there a corresponding command for 6500 chassis?thanks

Hello,I have interesting and strange issue at the moment. I have two 4500 L3 switches with 2 GB port-channel between them.I can't see any errors, latency between them. When i ping our office which is on MPLS from switch1 I am getting 100 % success ra...

I cannot get two frame relay serial interfaces to communicate. Can any body help. Why wont Serial1/0 is up, line protocol is down (looped) ping each other?Router 1---Current configuration : 1465 bytes!upgrade fpd autoversion 12.4service timestamps de...

Anyone know the maximum number of IPv4 routes supported per VRF (using VRF-Lite) on a Cisco 3750E stack (two switches in the stack)The current SDM template is 'desktop'

Hi,I have a small cisco switch cluster (seven different 2924, 3524cisco switches) with 3550 as a cluster control which does all the inter vlan routing that works fine.This cluster is in semi production PBX interop testing lab. This is a closed networ...

Hello all,I have a client that that is installing a new network.  They have requested the use of an CISCO891W-AGN-A-K9 mostly to be consistent with upgrades perfomed at other sites.  I agree with the use of this router, so that's OK.  The issue is th...

After trying to downgrade a Nexus 7K from 5.2.1 to  5.1.5 by updating the boot & kickstart boot statements and reloading, I'm now stuck in an endless cycle of reloading. See below:Is there a break sequence which will allow me to modify the boot state...

Hi there.I have a stacked Catalyst 3750 configuration tat i'd like to enable inter vlan routing on.I have the following vlans configured and have enabled inter vlan routng on them:VLAN 192: IP 10.192.0.1/23VLAN 193: IP 10.193.0.1/23I have applied thi...

Hello Community,could you please provide some insight on the following issue?We have two switches WS-C2960S-24TS-L running in stack with running IOS c2960s-universalk9-mz.122-55.SE3.We have connected two checkpoint devices on Gi1/0/24 and Gi2/0/24 wi...