Switching

Hi All,I'm looking for a detailed information about Bridge Assurance protocol  i.e. rfc, specifications etc.Can anyone share with me any links that discuss deeply about BA protocol ?ThanksArtur

Hello:I was wondering if anyone can help with this.  I have a cross connect from a ISP to our switch.  The ISP is also using a switch.  They are using a Foundry switch and we are using a 4948 switch. Both ports are 10/100/1000 copper ports and have s...

Hi All,Could any one please help !!!1.what is flash and bootflash2.can we have both in same L3 switch.3. why some models have only flash or bootflash and what it the significance of both.Thanks for any help.Regards,

Hi all,We have a VSS core switch and one VSS distrubution switch, connected via 4x 10GE l2 Ether-channel using pagpall 4 links are connected to a WS-X6716-10G-3C (on the 2 VSS systems (see drawing)). sporadically one link (link 1/3/1, we assume that ...

We’ve got a connection problem in a office. A computer is plugged into port #35 on the Cisco switch (2960). It is connecting at 1GB speed.  It is not able to connect to the network or the internet.But, when plugged into a Linksys switch it connects j...

Hi allIn our 3-layered cisco campus network we have several VTP domains. One of em has several 2960 access layer switches in stacks, a distribution layer (2x 3550 with L2 interconnects and HSRP) to form the L2/L3 boundary, and both have their own upl...

This should be an easy question. For SSH access:Why does this work?Standard IP access list 2    10 permit 172.16.2.0, wildcard bits 0.0.0.3 log    20 permit 172.16.1.32, wildcard bits 0.0.0.31 (6 matches)    30 permit 208.x.x.0, wildcard bits 0.0.0.2...

Hi all,I came across a setup yesterday whereas there was a Layer 3 Port connecting to a Layer 2 access port on another switch. The layer 2 port was a member of a VLAN that had a Layer 3 SVI.The switch with the Layer 2 port is still part of the EIGRP ...

HI ,   I have configured port secuirty on Cisco 4510R with Sup V and 4506 with Sup II plus (maximum mac address 2) .I have connect like belowLaptop-----IP Phone-----Switch. while I unplugged Laptop and plug in another port in same switch (4506 with S...

Hi,How can i prove router send netflow out to server? I received complain from server team didn't get any flow from router but i checked 'show ip flow export' and interface which server connected, is that enough? Thanks

I have a simple question for everyone.I have a 2801 router with a HWIC-3g-CDMA-S card in it , it is stated in Cisco's documentation that a solid signal is between -85 and -90dbm but it does not show me where to look for this figure or how to get to i...

Hi allRegarding to the attached network diagram, I've made some classification and policy-maps. Some users complain about poor voice quality, therefore I hope you will check my QoS Configuration.We are using softphones, on Windows Vista and Windows 7...