Switching

hi all,i have a lease line with an ISP on a branch office and it always gets congested due to high downloading stuff. i thinking of setting QoS on this link. can anyone advise what is the minimum discouraging data file size (or policed) that should b...

Hi allIf I want to restore a backed up config to my cisco WLC 4404 how would I do this if the controller has been reset to factory defaults. what is the easiest way?cheersCarl

Hi everybody.Its possible that we can have 2 DHCP Servers in a single network? how is the method to avoid conflicts? when the leased time expires could be any kind of problem? how can I avoid it?I found the following error in a LAN switch in our netw...

Dear All , We are usng a Cisco 6509 running CatOS 7.1(2) to apply QOS Policing for Rate Limiting. The QOS Configuration we usually use are as follows :Example : Subnet = 10.150.10.0 / 24" set qos policer aggregate Example_Dwn rate 256 burst 64 drop  ...

We are using Cisco Works for managing all Cisco Device.Cisco work Campus Manager >> Endhost Entry Display Mac-address only not showing IP address.So we are test on Switch (2960 IOS Ver 12.2(25r)SEE1)Show ip arpbut it is show only native (vlan1) entry...

Hi,From : Cisco Catalyst 2960 Switch Q&AQ. What are the notable differences between the Cisco Catalyst 2960 LAN Base and LAN Lite switches?A. Cisco Catalyst 2960 LAN Base switches have several advantages:• Gigabit Ethernet connectivity in 8-, 24-, an...

I have a Catalyst 6509-E chassis that was recently replaced due to backplane failure.  A 10GE line card was installed in the chassis and during the installation, the backplane failed.  The chassis has been replaced and service is resotored.  However,...

Hi All,I am just looking for some clarification regarding VSS...I have read that with the latest code for 6500 VSS, I can use Dual SUP in each chassis. Can I use a 10gb port on each Sup for VSL? Is that supported? Or Do i need to use a port on a 10g ...

Hello,I am looking for a router that can do the following configurations:- 1.5mb T1 line for failover- 20mb cable modem line for our main internet access- VPN/remote access- Gateway/firewall- VOIP capability for future use- RIP- Port forwardingCan an...

When I tested a switch through the web interface of CDM certain ports showed no activity or packet transfer (no clear counters either) yet when I put a Fluke tester on one port that had no activity a link light came up and a ping was successful any i...