Hello,I have a simple question that I can't answer.I have a Cisco 3750 that whenever I pefrom the command "Show interface vlan2222 | i rate " I get the following output:Cisco3750#show interfaces Vl2222 | i rate Queueing strategy: fifo 30 second i...
Hi all,Have a 6506-E with SUP-720 running s72033-pk9sv-mz.122-18.SXD6.binI have traffic coming in on two devices connected to GigabitEthernet1/9 and 1/10 which 'should' exit on interface GigabitEthernet2/36 due to a static route.However if GigabitEth...
Hi,I have the following switch at one endCisco Catalyst 2950C 24-24 10/100 ports and 2 fixed 100BASE-FX uplink portsconnected via fiber to Cisco 4506 ModuleWS-X4306-GBCatalyst 4500 Gigabit Ethernet Module, 6-Ports (GBIC)WS-G54841000BASE-SX Short ...
Hi Folks,I have some doubts about designing a topology for VPN.I have 2 6506-E Switches and three fiber optic rings for local branch offices. Each ring begins on one 6506-E Switch and ends into the other 6506-E Switch. I have ASAs 5505 in each brach ...
I'm doing a Boson practice exam and I started out as pretty confident, but right on question 1, even the correct answer explanation doesn't make sense to me. I'm going to post questions I don't understand as I go on with the exam. Any help would be a...
I'm having some problems trying to get tacacs authentication/ authorization working with my Nexus 5010 version 4.1(3)N2(1)Would someone mind sanity checking my config? I've included the logs from the nexus, and the logs from the tacacs server. The ...
Hi,I wish somebody can help me with this.There's a device that we don't manage that is attached to one of the switch's port (3560)The device is not allowed to respond to ICMP.Here's the deal...Previously from the network, we can reach that device via...
hi! I tried to configure my cisco switch with the followig command(config)# enable secret abcd(config)# line con 0(config-line)# login password 1234(config)# line vty 0 15(config-login)# password 1234but somehow the password of 123...
Hello Everyone ,I'm configuring my Cisco 4500 for exporting the netflow packets for view traffic detail for protocol and ip adress.I'm see via Wireshark, the packets are send to my computer in the port 9996 and version 5. I'm using ntop for recieve t...
Dear All,I am needing to change the internal IP scope for my network, however, when I make the change in my DCHP server I cannot change the Interface IP for my ASA 5510. Any ideas?I have tried editing the Inside Interface Ethernet 0/1 AFTER the DHCP ...
Hello all! I am trying to connect 2 catalyst 2950 switches and having some difficulty. I have the crossover cable connected and the LEDs are both green. I've setup the smart ports through the Network Assistant on both ports to 'Switch'. When I lo...
