Trying to set a switch as the member of a cluster but I keep getting the serror "This command runs only the command switch"cluster member 3 mac-address H.H.HMakes no sense to me.Anyone?
I have a 3750 connected to our providors 3400. The connection had some issues this week, where I stopped receiving input packets, although the link remained in up/up state. Bouncing the interface did not bring it back up. However, changing the neg...
We inherited a 4510 switch with dual SupV and are trying to connect them to a 3845 router. I purchased WS-5483 (copper GBICs) to accomplish this but they aren't working. From everything I've read, these should work fine with these supervisors and t...
Just began configuring a WS-CBS3130G-S today and have run into a problem with my port channels- can't get the interface to go into trunk mode.Has anyone seen this before?(config)#int po 20(config-if)#switchportCommand rejected: Not a convertible port...
I need some clearification. If i have igmp snooping enabled on a 7609 router. I have configured a vlan where other routers connect to and are then connected to the network. This in a sense creates a lan. When i do a show ip mroute I get serveral ...
Do you happen to know if there would be any issues channeling between a port on a WS-X6724-SFP card and a port on a WS-X6748-GE-TX card? I think this would be okay since they both can run at gig, but have seen some strange issues with etherchannel...
I was looking at the part numbers on the Data Sheet for the new Nexus 5000 series switches. The part numbers are interesting in that there are numbers for the chassis, Power Supplies, Fans, Software, Software Licenses, Expansion Modules, Cables and ...
We are running with 4506 Switch, the power down activity was scheduled due to maintenance, however, when we powered ON all the devices, the configuration of the swtich was gone, it came as if it was a new Switch with "Switch>" prompt, the configurati...
Hi all I'm trying to understand how to assign IP addresses to my network equipments.I have planned to use:- Router ISR2801- Catalyst Express CE520G-24TC (gigabit)- Catalyst Express CE520-24PC (POE, 100mb)- Access points- IP Cameras- ESXi Server, (mul...
I am having a problem setting up IRB between two 1721's on a PPP link. The routers see each other fine, but they cannot see the switches that they are respectively connected to (via ping).The switches also do not show up in the router's ARP tables.He...
I am using a Cisco 2511 as a terminal server. I connect the octopus cable to serveral Cisco router consoles.Connections work fine. When I disconnect the session on the router with the "exit" command, it should pop me back to the Cisco 2511 command pr...
HelloOn 4500 two VLANS are configured ; but transfer rate is very slow between two vlanscopy a file from one vlan to another vlan is slow its 20Kbps, host on both vlans are connected on 10/100 portsVlan 5interface vlan 5ip address 192.168.1.1 255.255...
Where is the fast cache data stored say on Cat 6509 switch? On PFC?Also when monitoring packet through a router interface, fast cache is disable (no route-cache to turn off fast switching and turn on process switching) what is the main reason behind ...
