Switching

Discuss Catalyst brand switches with peers and experts.
cancel
Showing results for 
Search instead for 
Did you mean: 
cancel

Labels

Forum Posts

Hello, Cisco Community!I’m really happy to share that I’ll be hosting the Cisco Community Lab Series, a brand-new hands-on learning journey designed to help you build practical networking skills step by step.Every Thursday at 8 PM EST, I’ll post a ne...

Hi Dears,I am Saravanan, working as a network engineer. In one of my customer have 4Mbps Internet, They have 4 vlan groups. Now current setup is Sharing the 4 mbps Internet to every body, but they want to limit the bandwidth in vlan groupwise.Conside...

Hi, I have a 877w running IOS C870-ADVSECURITYK9-M, Version 12.4(24)T2. For some reason I cannot get my wireless speed to go above 1.1MB/s.Both NICs on my notebook and media centre are set for 802.11g. I also brought a 3rd computer into the mix and t...

Hello experts,I have an old Cisco 5505 core switch (CAT OS), I want to save the running-config on a TFTP server. I'm not really familiar with CAT OS, please can somebody guide me on how to save / restore the running-config of this old core switch to ...

Hi, I am facing issue while converting Cat IOS to native IOS in WS-X6K-SUP2-2GE. Chassis is 7606.In conversion procedure, we have to take this SUP in LAN (for ping TFTP Server). But Ethernet port is not in SUP. Can I do this conversion through consol...

ikbalc by Level 1
  • 762 Views
  • 4 replies
  • 0 Helpful votes

hello,i'm working on a setup of 3560 switch. it will be a core switch for an office of about 60-80 people. my access layer switches are unmanaged 24-port linksys switches. my question is: if i run 3560 in L3 mode then every interface needs to be a se...

george by Level 1
  • 2274 Views
  • 3 replies
  • 0 Helpful votes

Which one of the methods below, in Layer 3 switching, uses a forwarding information base (FIB)?A. Route cachingB. Demand-based switchingC. Flow-based switchingD. Topology-based switchingmy answer (according to the CCNP BCMSN for David Hucaby) Page 29...

amrelec by Level 1
  • 817 Views
  • 2 replies
  • 0 Helpful votes

We're in the process of upgrading 3750 switch stacks in our organization.  The stack varies from 2 to 5 switches.  We have upgraded about 15 stacks so far.  But 2 out of 15 stacks, however, have failed during reload.  We had to disconnect the switche...

rrdumag67 by Level 1
  • 1423 Views
  • 4 replies
  • 0 Helpful votes

Hi,I am trying to get 802.1x port based authentication working on a cluster switch member. All the switches are 2960 series veriosn 12.2 (44) SE2. Only the cluster commander has an IP set and that is configured on the radius server (Windows 2008 NPS)...

You can configure HSRP in networks that run which of the following protocols (Choose all that apply)?A. Banyan VINESB. IPC. IBM DLCD. Novell IPXE. AppleTalkAnswer: A, B, D, E I believe that HSRP is a cisco-proprietary, so my answer was "B" only.Why t...

amrelec by Level 1
  • 3594 Views
  • 4 replies
  • 0 Helpful votes