Switching

HI Experts,Can you please tell me the best study guide to go through my ccnp first module ??Best regards,Nuwan

We have established connection between two router via STM link .Before changing the framing to SDH in my router , there were alarms in local & remote router & it was not possible to ping . Now after changing framing as per show interface the line & l...

So I have currently 32MB of flash, and I bought a 16MB of flash to increase my flash for 48MB of flash. Well the only problem is this. I have a 2621xm router, and I see I have only one slot for flash. I'm trying to load CCME 4.1 on my router, but if ...

My router is a 2811 running Version 12.4(9)T6image is flash:c2800nm-advipservicesk9-mz.124-9.T6.binThis router is the internet router and there is a PIX515E behind this, email server is a Exchange server with MS-NLB load balancing two servers (10.y.y...

I have a customer that is using dhcp snooping on their access switches, I have not done dhcp snooping in my career but I only see this issue where they have cascading l2 switches installed. When using a l2 switch with 2 more l2 switches, all configu...

I am looking to configure LACP on 3750 and wondering if there are any special considerations I should be aware of like minimum IOS level or something like that?Will rate posts.Thanks!

Hi All, Is there a way on a cisco switch to verify how long its been since Spanning Tree has re-converged, or even to see what *revision* number of STP is running. Essentially I want to see if spanning tree is constantly re-converging and causin...

Could someone please tell me if a mac address is getting created as a result of creating a layer 2 Vlan?Thanks..

Is their a command that can be run on cisco routers that will turn off fragmentation?

I want to use two different 0.0.0.0 routes on a customers switch. This so that I can load balance between two ISP's. Can I do this?Example. Default route 10.0.0.0 0.0.0.0 206.248.224.1Default route 20.0.0.0 0.0.0.0 205.148.221.1

Hi all,I am facing Performance problems in our LAN.We have 6 Vlans , one of which is server vlan others are users Vlans.Problem is that when i ping from users Vlan to Servers Vlan i found high latency ( like 20 to 30 msec)We are using two catalyst 4...

I need to configure web authentiocation on 2960 switch with Software (C2960-LANBASEK9-M), Version 12.2(52). Here is the configuration used on the switch:aaa new-modelaaa group server radius accounting-group server X.X.X.X auth-port 1812 acct-port 181...