Switching

Hi Guysi have to rate limit the bandwitdh from a specific subnet going to a particular server.i plan to use MQC policing so whts u r advice this.I am confused abt some terms in rate-limiting.i understand the confrim action and exceed action not sure ...

We have clients that would like to connect non-Cisco switches to Cisco switches. I have been told that this is something that Cisco TAC will support, and is fully supported, so far as the non-Cisco switch supports the sameindustry standards that Cisc...

Dear All,Intermittent Jitter failure in Cisco 2821 router. Show IP SLA satistics output gives "Latest operation return code: Socket bind error". Reachability between source and destination is perfectly fine and no packet drops.***********************...

We have three servers with IP 172.16.10.1 connected to three different switches (trunked together)but I am seeing Duplicate Address error on one of the server and that too on alternate day basis e.g. 7th July then 9th July and then 13th July. Am expe...

I try to limit the access to my switches using a mac access-list that allow only certain mac to do ARP and assign this filter to a particular vlan.I setup it as follow:*************************mac access-list extended Allowed-mac permit host 0002.b30...

The topology is in attachment.All routers run both RIPv2 and OSPF.Attempt this exercise based on what you know about OSPF, Dijkstra'salgorithm, and the distance command. Using only the distance command,write out the commands necessary to confuse the ...

Hi, I would like to know what kind of STP can be used where the distribution switch is Cisco and the access-layer swithes are pro-curve switches. Is RSTP and MST the only option here. Currently my Cisco distribution is running pvst+.Pls advice,...

hello,i have two link which i terminate on 3 layer switch. and other one link which i got from firewall, now tell me what ido for communication between this three linkall link address r differentlink1 10.10.20.1/24link2 10.20.20.1/24link3 10.30.20.1/...

Hi NetproI have a Cisco Caltalyst 2950 whit c2950-i6q4l2-mz.121-22.EA1b.bin IOS, this IOS in feature navigator show have AutoQoS feature but when i try to configurate auto qos voip cisco-phone on interface don't have the command.Any idea?Regards.

Hi, I have a 2960 connected to a 3560 at 100/full. The port shows up w/ errors but I cannot ping the vlan on the 2960. Auto mdix is on. Any thoughts?Thanks

In catos (5.2) show config, the config is empty for one module, at the same time in sh config all i could see the config for the same module what is the reason for this behavier

Hi,Customer requirement is to:a) mark traffic from Exchange Server destined for Blackberry Enterprise Server at another site to AF21. The BES server ip address is 10.202.1.76.b) mark Citrix traffic as CS4.I've attached part of the configuration. The ...