Hello,I am a little confused with how to use the ip default-network command to configure a default route. Can someone explain the difference using "ip default-network" and "ip route"?Thanks.
Hi,I have purchased the cisco 3750 switch from cisco retailter that comes with the IP base image. I want to upgrade it to IP services image to have more functionality. Does it require to purchase the licence? I have the CCO account and can download t...
Hi there"we" have a Catalyst 3750 switch on which we configured 2 static routes. See attachment for the logical design.We configured the following static routes:ip route 192.168.0.0 255.255.0.0 10.0.0.11ip route 192.168.64.0 255.255.255.0 10.0.0.12In...
Hello : My customer is seeing frequent neighbor flap .ADJCHANGE: neighbor x.x.x.x Down BGP Notification received .Jun 2 14:07:56.705 BST: %BGP-5-ADJCHANGE: neighbor x.x.x.x Up While troubleshooting the issue I have found that the BGP time is set i...
Hello,i have 4 different ip networks like:layer 3 switch:192.168.0.0/26 GW 192.168.0.1192.168.0.64/26 GW 192.168.0.65192.168.0.128/26 GW 192.168.0.129this one is on a layer 2 switch192.168.0.0/24 GW 192.168.1.1all the communication should use vlan 2!...
Hi,I am experiencing an issue with Proxy ARP in my network, but only for one server.Our DG on our netowrk is an ASA 8.0(3) that has Proxy ARP enabled due to allocating a portion of the same internal range to remote hosts. I have one server on the net...
Hi,Thanks in advance !I have struck in upgrading IOS image for few switches from TFTP server. All switches are in 10.10.29.X network. Atlast I found that these are blocked to access to server where IOS image is saved(TFTP). I am able to ping any swit...
HiMy Cat4506 didn't show terminal logs when i changed configuration ex. i shutdown interface but it showed only "%SYS-5-CONFIG_I: Configured from console by". I configured logging buffer debugging and logging monitor debugging , it should show the lo...
I have a couple of 3560 switches and I had Http enabled (LAN), now for some reason i cannot get to them from inside the network using the internal IP address. Can someone give me the command to do that?
Need help configuring the cisco 2600 router to make sure the two subnet are directed thru two separate ports to a firewall. Then, from the firewall it connects to my internet service provider.1) The security levels including port traffic allow indivi...
Say i have one distribution switch connect with a fibre from BLK A to a stack of 3 switches in BLK B. I discover the uplink interface with CRC and inputs errors. 1) Does it means that the error occured between the uplink of the stack switch to the di...
