Switching

Hii have 40mbps metro link terminating on 3750 switch.the link is between 2 office and carries data & voice traffic. i want to restrict my data traffic to 20 mbps.i am defining the access list to match my data traffic and calling the same in class ma...

I have two distribution switches that have a VSL link between the two. I'm having an issue trying to connect these 2 switches to 2 3750 stacked switches. The way i have it currently setup is that I have one connection from vss 1 and one connection ...

Hi,CCO documentation states that"priority-queue queue-limit" command is supported in 12.2.18SXF2 and above for Cat 6500, Sup720-3b.For IOS below 12.2.18SXF2, what is the buffer that is allocated for priority queue?Using 1P3Q8T as an example, if i hav...

Our ISP going to connect leased thru Ofc cable. They are telling instead of using G.703 and V.35 Modem we can go for G.703 to V.35 Converter. What is G.703 to v.35 converter? How to use this converter? If anyone having image of this converter pls pro...

Hi, I would like to check if there is a class-map statement as follows:-class-map match-all Data match ip dscp cs1 af11 My question is that would the class-map be effective when both cs1 and af11 present or is it an OR operations ?Thank you,...

from ciscoCan we pull network usage statistics 6500 switches,Is there any command, OR any other monitoring software.I have a cisco works LMS.But i dont find any such template or similar like Network utilization report that can help me.

I have two switch and a router.I will name them switch A and B. SwitchA is connected to f0/0 of the router and switchB is connected to f0/1 of the same router.SwitchA is connened to a lan network which is 172.1.30.0/24 network.which the interface f0/...

Hi All,i got in trouble with SPT with Cisco 6509 .The four switchs are link with 802.1q trunk, the port cost is show on diagram .I setup vlan 3808 on four switchs and router ,ip address as below.s3:1.1.1.73s4:1.1.1.74s5:1.1.1.75s6:1.1.1.76router:209....

Hello all,i'm using a Catalyst 6500 in a datacenter as a VTP server with about 15 smaller switches (2950, 2960, etc) connected to it in VTP client mode. Yesterday i added a pair of new VLANs on the 6500 and saw that all the 2950 switches went into tr...

I got this error mesage in the log:"%EC-SPSTBY-5-CANNOT_BUNDLE_LACP: Te5/5 is not compatible with aggregators in channel 4 and cannot attach to them (qos-card types of Te5/5 do not match Te6/5)"According to Cisco error message decoder:"%EC-5-CANNOT_B...

Hi, would there be a database to look into when the default behaviour of a command changed in IOS besides going through the release notes. I am looking at the command lookup tool and all it does is gives when the command was introduced and when the c...

We dropped a 6500 with no power supplies. We had to prop the bottom of the chassis with wood to get the power supplies in. What commands are available to take a look at the hardware and see what specific problems exist with the linecards, supervisor ...

Hi All,I am facing a issue in 3750 switch .The switch is connected stack .The switch is working randomily.if u removed the power connector and connect back the switch working normally.I am attaching the show-tech support report.