Switching

Discuss Catalyst brand switches with peers and experts.
cancel
Showing results for 
Search instead for 
Did you mean: 
cancel

Labels

Forum Posts

Hello, Cisco Community!I’m really happy to share that I’ll be hosting the Cisco Community Lab Series, a brand-new hands-on learning journey designed to help you build practical networking skills step by step.Every Thursday at 8 PM EST, I’ll post a ne...

Hellowe are expanding a trunk port over a L2TPV3 tunnel (in port mode):trunk port <-> 2811 <-tunnel-> 2811 <--> trunk portEverything works fine but VTP updates are failing.Sniffer shows that VTP packets are out of order after the tunnel. There a 3 pa...

tgusset by Level 1
  • 731 Views
  • 1 replies
  • 0 Helpful votes

Hi,we are using 12.2(18)SXE6b on a C6509 with a WS-SUP720-BASE supervisor. A Cisco engineer told us we should upgrade, as the image is deferred.Using the software advisor, I cannot find an IOS compatible with the WS-SUP720-BASE, as it only gives me t...

I have a Cisco ASA 5505 in place at a client, and I've got a PC on the network infected with a spambot sending spam. I need to block port 25 to all PC's on the network EXCEPT for the Exchange server. I created an outbound ACL rule on the outside inte...

I dont know if any of you guys can help me out with this, but I am kind of stuck. Equiptment:Linksys RV082 dual wan routerCisco 2821 integrated service routerWhat I am trying to do is connect the RV082 to the 2 ISP's I have coming into the building(...

Dear Experts,I tried to install 2 HWIC 4ESW modules to 2821 routers. But only one slot working properly 2nd one shows everything fine but cannot ping or layer 3 activity not showing. But according to Cisco website it suggest 2 HWIC we can install. Is...

arulgobi1 by Level 1
  • 558 Views
  • 3 replies
  • 0 Helpful votes

Hello, setting up a new vlan and in adding the IP helper found out that we now have 2 PXE servers(Altiris) on another VLAN and need to account for both. Can there be 3 IP helpers with 2 of them being PXE servers? will that even work?int vlan x ip a...

Hi all,I have configured SPAN on 3750 switch and couldn't see any L2 protocol updates on destination port.is it normal behaviourand I am aware on this# A destination port does not participate in spanning tree while the SPAN session is active.# When i...

I'm trying ot install SDM on a 2621XM router. I run the install, it connects to the router, Install Cisco SDM Express is selcted, space required is 2493 and space available is 4445.The install goes through Enabling RCP on your router, Checking Memor...

Unanswered Topics