Switching

hi allI need to create management vlan with ip 11.14.10/24 in the catalayst 6500 seris switchthe gate way ip to be used for new vlan willbe 11.14.10.1could you please any one tell me how to configure with commads and please share me the documnetalos ...

HiI got a Cisco router, it is also the DHCP server of my network the detail are below.For some reason the server randomly stops serving IPs to workstations, even a repair conection does not work. Some computers have a valid IP but it does not get ren...

Hi, I'd like to mark incoming UDP packets with DSCP values on a 6509 with Sup720 3BXL. Incomming interface is a WS-X6748-GE-TX What I did is---------mls qosclass-map match-any UDPKRAM match access-group 100policy-map UDPKRAM_AF21 class UDPKRAM se...

Hi All,I need the operational and technical difference between the following products.1. WS-X6148-GE-TX2. WS-X6548-GE-TX3. WS-X6748-GE-TXThank you,

So this is probably a very easy question and I've done some searching on the net but can't seem to find an answer. Does anyone know what the asterisks * means when in front of any given log entry? I noticed that some log entries have them, yet some d...

Hi All,We are running a network management system (NMS) that executes applications then monitor and control managed devices. Like Network elements -- routers,Switches.We need MIB-OIDs for Cat6500,Sup720,Fan tray and power module. OID identifies a var...

Hi all,I would like to test MS windows server 08 dhcpv6 stateful server but It (of course) doesn't work.The client is in a subnet with a catalyst 3560 configured as a relay agent :ipv6 enableipv6 nd managed-config-flagipv6 nd other-config-flagipv6 dh...

Hi,I have issue with setting speed and duplex on a 100 base fx sfp, on a 2960 running c2960-lanbasek9mz.122-25.FX.bin. problem is, its autonegotiating with a 2912 at half duplex.Thanks.

Hi,Can anyone in Cisco confirm when the 3750 and 6524 metro switches will be supplied with 10Gbps ports.Regards

Hello,I have Cisco 1841 that is providing NAT overload (PAT) for a LAN.I have 2 LAN's using the same IP range. Basically one LAN has the servers and many users and the other LAN has just users.What I have is the router doing NAT overload at this rem...

Hi,I'm looking to set up VLANs on a Cisco 877w (Base Image), AFAIK this should support 10 Wireless VLANs and 2 Wired VLANSI have set up the Native VLAN as a Bridge and incorporates 3 of the switchports and the DOT11Radio0.1 Interface and works fine.I...

Dear;we ahve dhcp server in one lan segment 192.168.20.x, we are planing to create another lan segement for which we want to use same dhcp server , we configure scope for two segment in dhcp server.do let e know how can i configue dhcp relay on cisco...