Switching

Have a Cisco 3560 switch with multiple VLAN's. Have a vendor that connects to teh Pix 505 with PPTP and gets IP from server on VLAN1. They then need to connect to a PC for RDP session on VLAN2. I am unable to get that connection working. Can ping...

I have a dude.I'm thinking to buy a Cisco Catalyst 3560-48ports, that swith will have three vlans, and I'm planning to create three port mirroring to monitoring the traffic.Well the questions are: what about the swith(memory,wideband)?, that switch s...

Anyone has an idea how to configure Layer3 spanning?We have a small site with access to the Internet but want to use Websense which is currently in a different site. So spanning the traffic that is destined to the Internet to go through Websense is ...

there are 2 routers-A & B.Both are connected via an ethernet link running ospf on each of the link terminating interfaces.Router B shows in init/drother when checked from Router A.Interface on A that connects to B is up/up & ISP has confirmed the lin...

Hi Everyone,I have 2 6509's configured with an SVI directly connected to a pair of ASA's in an active/standby failover configuration.The design requires the use of 2 static routes, one floating for failover. The primary route is destined for the pai...

Does anyone know if switches will go into STP learning mode during the time when the root bridge sends Configuration BPDUs with the Topology Change bit set to 1? I understand that the Topology Change process is used to age out the mac-address tables...

Is there a way to get a host on a L2 switch to do IGMP joins to across a dot1q trunk to a multicast source on the same vlan. The source side has a vlan interface created the host side is strictly a L2 vlan.

throughout the network...good or bad?Please share your experience and thoughts..thanksAlex

Good morning.I'm looking for a way to identify the power source (AC or DC) on Cisco Catalyst switches 355024 and 295024.Is there any command I can use for identifying if the switch in question is AC or DC?

Dear expert, I am testing the the dot1x feature and get the below result. I feel point 4 is not quite make sense.Can I make that for dot1x client, Even they haven't enter their username and password, they also willnot be assigned to guest vlan ( vlan...

I have recently purchased a used 2621XM router and have found that when I turn off or discconnect the power, the config is not retained.... and before you ask, yes, I have saved the config from running to startup.The only change that I have done afte...

ping from PC1 can not reach R1 and PC2.I don't know why. I'm testing Vlan principle. Can anyone help me?R1 : E0 10.43.6.1, E1 10.43.4.1SW1 : 10.43.6.2 SW2 : 10.43.4.2 PC1 : 10.43.6.5 PC2 : 10.43.4.5E0 from R1 connects Port1 from SW1...