Switching

I am trying to decipher what each of these are. My understanding is that one of them is a cisco proprietary version of STP, and that 802.1s is a standardized version that opperates similar to the cisco one, but the descriptions and whether is MST MST...

Switch#sh runBuilding configuration...Current configuration : 2455 bytes!version 12.1no service padservice timestamps debug uptimeservice timestamps log uptimeno service password-encryption!hostname Switch!aaa new-modelaaa authentication login defaul...

Currently I'm using 2x3845 routers with 4x 16 port SSC cards. Each serial interface is set-up with an IP address and a peer IP address. (Please see attach configuration).I log into the router using a Linux laptop. I'm unable to ping the serial IP ad...

Every time I save a configuration with "write memory" or "copy running-config startup-config" the router doesn't keep its settings when I turn it off. When it comes back on it just asks me if I want to enter initial setup. Then I have to manually c...

Hi all,As part of a provisioning test plan I need to break a 3750 stack. Is there any way I can achieve this remotely? i.e. without going to site and physically removing the stack cable.Thanks,Andres

Hi allI just wanted to know what is the max number of LACP channels that can be configured on a Cat3750G-24TS-1U switch? Tried looking on the net but can't find one. Thank you.

Hi, On a router RIP V2, is it possible to prioritize a road than another if two roads are the same cost due to an active redundancy? Thank you!

Switch model is cisco 2948G-L3 it is in ROMmOn mode i am not getting doc how to upload the ios through Rommon

I'm putting together a design for a transportation scheme. I need to know how many instances of HSRP the switch can support as this dictates the number of VLANs that can be provided.

Hi,I have a question for you all.I try to do vlan mirroring on C6509 switch. And I did it like below config.Btw, is it the correct config ? I need your advice.Thanks so much.#switch port analyzerset span 3-5,7-9,32,34-35 3/5 both inpkts disable learn...

hi thereI got a really messed up Cisco 3620 Router here. I got it from a collegue who told me I'll have to repair it first before I can use it. I need that one for a testing environment. When I start it up using HyperTerminal to monitor the output I ...

Hi All,The scenario:Office LAN connected to ADSL line through a 851 Router (static IP) . LAN clients should have internet access through FE4 (ADSL Static IP)Also remote users should connect with cisco VPN Client.i have tried the configuration on my h...

Hi, I would like to check if there is a command in ospf to check the start time since the neigbors established relationhip, to FULL state. I could not find any commands for OSPF. In BGP, it has the command 'sh ip bgp sum' and it states since when ...