Switching

I currently have an 837 with two subnets off it, one attached to the eth0 interface and one attached to the eth2 interface, each one has a small switch and a bunch of pcs behind. The subnet attached to the eth0 is 192.168.10.0/24 and 192.168.64.0/24...

As I understand that we can NOT assign specific bandwidth to any P and Q queue with PFC QOS configuration, can I use “wrr-queue bandwidth” and “wrr-queue queue-limit” or any other way to achieve the requirement as following:It is WS-6724 (1p3...

Testing the waters to convert my 6513 hybrid config to a Native config. Cisco has a Catos-to-IOS converter. I ran it and can't see how this thing is going to work. Below is what It translated just one port to native OS. This is a switchport on vlan24...

Hi I have a switch requirement for initially providing 100M ethernet with 1G uplink which needs to scale to 1000M access ports with multiple 1G uplinks or 10G.The 1000M ports however have to be optical while the 100M copper (RJ45) so I guess what I a...

Has anyone experience or know of any limitations with the 6148 module ports? We are running some markets data applications and noticed drop packets on the transmit and slow performance. The module only supports 10/100.

I have a Cisco 6509, where we are doing port channels/aggregating ports to a HP chassis. In any case during the initial setup we made some extra port groups. And being the good admin I wanted to clean up the extra port channels.Well right after I too...

I would like to see if I can simulate a WAN link between a test LAN and our corporate LAN.We are moving equipment to a datacentre and have been provisioned with a 20MB connection from our building to the datacentre.I would like to set up a test switc...

Hi AllJust a quick question. I have a private network (10.x.x.x/16) in a lab in work and I would like to be able to access this lab from our corporate network. I have a 7206 VXR at my disposal with IOS c7200-is-mz.122-23. I do not administer the corp...

Quick question. Have to add a subnet but am out of open fast ethernet ports on ouor router. I have an existing connection between 2 of our routers. If I add a secondary IP address on each side of this connection will I be able to route through the se...

I have a PIX506E as the firewall between my LAN and my ISP. The power supply failed and while waiting for a replacement, I replaced the PIX with a Netgear router. This worked for what I needed (Internet access for browsing and email). When I went ...

Hi,We have a campus designed network that have a core level: 10720 routers on a ring topology, a distribution level: 3750 switches with ip routing, and an access level: 2950,2960,3550 POE and 3560 POE layer 2 switches. I want to know how many switch...

Dear siri wanted to know that how can i hear voice in my voice vlan. as i m using 2801 voice gateway with PRI (only PSTN connectivity) ,and 3560 switch for voice and data vlan. My voice gateway IP is 192.168.1.221 and is data Vlan on port 7 as menti...

Hello,I am trying to configure OSPF so that in case of network split OSPF does not advertise a connected route anymore.I am trying to make this work like this.In case IP address 172.20.240.5 does not ping, OSPF withdraws a route for 172.20.240.0/29Th...