Switching

How can I get the Inside and Outside Global IP's when configuring my 871 Ethernet Wideband Router? The ISP doesn't provide them.

Looking for a telnet command that i can use to telnet into a ssh enabled router in from dos prompt.Please help , thanks.

Hi all,Currently, I'm using a Cisco 1721 Router at my HQ with 1 serial wan and 1 ethernet lan port for my network. This router is connected directly to a 8-port gigabit switch where all servers (all servers have 2 NICs but only using 1) and 2 Cisco C...

is it possible to setup two ASA's behind a cable modem? currently i have the modem, then a switch, then the two ASA's. one is configured with with pulic ip x.x.x.79 and the other is congifured with public ip x.x.x.127. however, only one will work at ...

Hi,In order to attempt a quick and dirty way of limiting the outbound traffic on our 3750 switch I attempted to simply use:srr-queue bandwidth limit 22on a FastE uplink. From what I understood the command should only limit egress traffic from the po...

ERSPAN solves a voice recording issue we see a lot in properly structured campus networks. A lot of Voice recording solutions require SPAN to be configured to replicate traffic to a server. In an IP world with IP Phones this is tricky as you either...

Anyone using Avaya VoIP phones connecting to WS-X4548-GB-RJ45V blades? Not all phones are doing it, and it happens intermittingly. We have Avaya troubleshooting as well. Any suggestions it will be appreciated! Patch cables are certified. ThanksDerek

Hi all,I want to install ACE20-MOD-K9 in 6513 Switch ,I install module in slot 5 and all other modules except supervisory engine get blocked ,Does anyone knows in which slot ACE20-MOD-K9 to be installed in 6513 SwitchThanksSudeesh

We have three 3750's in a stack, they all pretty much have one vlan spanning across them (they're access layer switches). One of our systems guys went into the closet to press the mode button, he was trying to see which switch is #1 in the stack...i...

From what I have been reading NetFlow is possible on the Catalyst 6009, however the ip flow command does not exist when I in interface configuration mode. I am running the Enterprise Lan feature set and the newest IOS 12.1(27b)E1. Does anyone know ...

We are at early days, but it looks like we have a bit of an issue with QoS marking.We have a client that wants several levels of QoS, and we have a cat3650 as access switch.We have traffic that should be TCP, but when we ran it from a traffic generat...

Hello,Is the 2950 Switch a cut-through switch?Can I enable fast-swithing, fragment-free sau adaptive cut-through?I've searched its Software Configuration Guide but no reference to switching methods. Thank you

HiI've run out of telnet sessions that I can use to connect to a 3560 switch. When I run "show users" I get:#sh users Line User Host(s) Idle Location 1 vty 0 idle 1d21h 10.11.11.2...

ho env allFAN is OKTEMPERATURE is OKPOWER is FAULTYRPS is SUPPLYING

Hi I am still getting familiar with Cisco products Can I put a Fiber Optic MM cable into a 24-port 3750 switch? Also if I want to gang 2 3750s together (48-port) what is the best way to do this?