Switching

if we need configure the port on the switch to allow voice traffic and data traffic, we have 2 kinds of configurations:confgiure1:switchport voice vlan 2switchport mode accessspanning-tree port fastconfiguration2:switchport trunk encap dot1qswitchpor...

We are redistributing certain static routes using a route-map. EIGRP also has "internal" routes for the destination subnets. How do we give preference to the redistributed static -- so that they are used and not the "internal" routes? Thank you.

I am going to insert a redundant Supervisor engine-2 in 6509 switch.What steps I should follow to install the same.Please suggest me with the detailed configuration

Hello,Any help or advise with this one would be appreciated!Topology Summary:I have a network across two floors (11th and 12th). The 11th floor is the core network with 2 x 3750G switches with enhanced IOS. These switches have 3 vlans, WAN (vlan 100...

Hi All,I have a router 2501.i am not able to connect it. when i connect the console cable, it doesnt show anything in hyper term. i had changed the cable and laptop but it still not accessible.when i try to telnet it through pc, it gives following er...

Hello,status:we have a switch with a vlan 10 and a vlan 900. VL 10 is our stand network and vlan 900 is a layer 2 vlan for a DSL connection.How can i detect / check when there is a physical interconnetion betwein those two ports. And perhaps shutdown...

I have a switch that shows the following 'show spanning-tree' output:VLAN0001Spanning tree enabled protocol rstpRoot ID Priority 24588Address 0012.d94b.fd00When I use "show mac-address-table | inc 0012.d94b.fd00", 0012.d94b.fd00 is not found...

Dear Netpro!I have Server with the Following ip:10.10.10.1 mac-address 00-05-5D-D3-62-4F.this server in same subnet.i want to add its mac address Manualy to Switch mac address table.how can i acheive that?many Thanks

Hi guys,I've a situation where my VOIP and DATA on a different segments. Voice is 10.x.x.x riding on VLAN 701. And my data is 192.x.x.x riding on VLAN 100. The problem occur when our receptionist PC have a software installed for call forwarding for o...

Hican i configure ingress in Cisco 6506-E switch. I can configure it 3550 and 3750. but in 6506 no command like this.thanksBiplob

Does anyone know what may cause these errors?show cef dropCEF Drop StatisticsSlot Encap_fail Unresolved Unsupported No_route No_adj ChkSum_ErrRP 1199571 0 0 61 0 06 0 ...

I am trying to replace a Dlink 614+ router with a 871W. The Dlink had 3 hardwired computers and one wireless connection connected to the Internet using Earthlink PPOE and DSL. The Dlink is configured with required PPOE Earthlink user name and passwo...