Switching

Hi there,Is it possible to setup a 2950 for HTTP Read Only access without a prompt for Authentication. If not, how can I set up a logon that would allow just Read Only accessCormac

hi, can any1 tell me a free tool ( windows ) to take bulk configuration backup, i found cirrus to be extremely useful but its not free so if any1 can help me out in this ?thanks in advance

Hi all, what does this light mean, if I have a carrier detect light but no line protocol what does it mean, can the circuit be active if the lp is down? also say if its an isdn line, how would I know its active would the lp be off or on ?

Hi all, if I have 2 routers using hsrprouter 1 ip is .1, routers 2 ip is .2virtual ip is .3when I do a traceroute to a destination, I see the path takes ip .1 then .2why is this ?

HiI have a question about DHCP server on cisco routers. I want to change the source IP address for the DHCP server to my loopback interface on the router, is that possible. For the client it should look like another server sent DHCP offer and ACK.I h...

Hello can any one have an Idea of binding IP address with MAC in DHCP in cisco router and switchsThanks in advance

hi,I would like to ask the difference between class based queueing and weighted fair queueing?which one is the recommneded to use?

I have a question regarding what the default gateway of a host should be.A switch has IP's for 2 vlans including the management vlan. This switch also has a default gateway statement pointing to the router interface. This is a switch at one location....

I notice that many vlan & vtp configuration commands don't appear in the config file for integrated IOS. What's a quick way to see and back up the current vlan & vtp configuration information? Ideally, what I'd like is something like the config file ...

Hello,Is it possible to run NAT inside on a sub interface (int f0/0.100) and not run NAT on another subinteface (int f0/0.101)?

Hello all - I have two 3550's and I have trunking enabled on the fast ethernet ports. I have tried to set both ends to 100/full, however they do not come up. If I go back and set them both to auto/auto they come up. Can I not set trunk ports to 10...

I am reviewing a config file of a 6500-SW and it shows that there are 5 VLANS configued. When I did a show cdp neighbor details, it only showed the default vlan (VLAN1) and no physical links to any other devices. This switch is offsite and I just got...

Hello everyone,I was hoping someone could shed some light on this command for me. I am setting up a syslog server on all the switches ( 3524xl, 3550-48-SMI switches ) and not sure how to use a command. I've set the IP address of the server, set the...