Switching

I have a 1751 router with a WIC-4ESW 4-port switch module in slot 0 and a WIC-1ADSL interface module in Slot 1; when I boot the router, it gives this error:"Smart Init is disabled. IOMEM set to: 20Unknown Card in slot 0%C1700-3-TDMMODIFUNKNOWN: TDM M...

HelloI know that there is a problem with hardware-switched packets and the command ip debug packet on Catalyst switches.How is the configuration on the switch to see all ip packet.Pascal

I'm under the assumption that if you're using hsrp that 'standby preempt' would be mandatory if you actually want the gates to failover. Is this true? If not, under what circumstances would you not want to have preempt configured?Thanks./rls

HI Guys,I'm just trying to get my Cisco Doc DVD April 2007 running in fedora 8. Does anyone had any suggestion ??cause i got this link :http://linux.open.ac.uk/issue59/lg_tips59.htmlstarting httpd for cisco documentation, but the document is too old....

Hi, Hi, I have a 2600 running flash:c2600-i-mz.122-8.T5.binSome static nat entries are configured, and I am seeing static routing entries being entered into the routing table without any configuration to do so. I don't see anything in the config tha...

Hi all, I'm trying to do a file copy from a server to my desktop that consists of about 6000 files. I start the copy, and get about 50 files copied and then my network port shuts off. I verified that I lose link light on the 6509 blade for my port. A...

Hi gurusI would like to setup a test site-to-site lab, I have two 871 routers and two computers for this purpose but what do I need in between to setup this test lab to work as they where in different place(state) and all. as you can tell I am new to...

I've got a supervisor card showing the following output:Self decompressing the image : ##############################System Power On DiagnosticsDRAM Size ..........................128 MBTesting DRAM .......................PassedVerifying Text Segment...

My router was unable to boot normally and none of the LEDs were on after 15 seconds of booting it. So I connected to it using PuTTY and here is the output:System Bootstrap, Version 12.3(8r)YI4, RELEASE SOFTWARETechnical Support: http://www.cisco.com/...

Is there any posibility to do this upgrade on a router 2821 from IOS IP Base feature set upgrade to ADV IP Services?I would appreciate any help!

Without going in to too much detail, could someone just give a brief outline on the benefits of upgrading Supervisor engine?Say from Supervisor Engine II to Supervisor Engine IV?Is it mainly just the overall backplane throughput that improves or are ...

Hi all, has anyone come across this issue, we are dialling up to a vpn using analogue dial, (phone number), this works from our office, and the user can make voice calls from her phone at home, but it will not let her dial up to the number at home, c...