Switching

I have just purchased a Cisco 1812 router and I am have Vlan problems with a Nortel 450 switch. On the Nortel switch I have 4 vlans.. Vlan 1,2,3,4 with port 1 vlan 1 port 2 vlan 2 port 3 vlan 3 and port 4 vlan 4.On cisco 1812 Fa0 is on Nortel port 1,...

Hi, all.I have a 2501 router. Everytime, when it starts, it stops, saying snmp agent on host router is undergoing a cold start...even when it wouldnt stop when i type break to go Rommon mode. what might be the problem. I've copied the message here.==...

Guys, apart from the bandwidth advantages, what are the other benefits one gains from upgrading from Sup2 to Sup720? I know there is CPU rate limiting. Does anybody have a link so that I can read about this.If you list out other features too, I'll re...

is there such a tool that will convert your CatOS based config to IOS based?? If so, where/how do i get it?Thanks in advance!!!=steve

Hi geeks, I've got a trouble as to the DHCP running on ASA 5505. It is not picking any external IP from ADSL router. Upon iterative modification and testing, still no luck in accessing Internet. My set up is: Internet--> DSL router--> ASA 5505 Here i...

I am planning to upgrade my Sup1A/MFSC1 6500 series switches to Sup 720's running IOS. At one time, I had a document from TAC that showed me a list of Cat OS commands and the equivalent IOD commands. I can't seem to find it, nor can I find it on CC...

Hello,A Cisco ATA is connected on a port of a 3560 which is configured to belong toa voice Vlan and also runs 802.1x MAB (mac-auth-bypass).Is this configuration supported ?.-If the switchport is configured only as a voice vlan port all is ok-If the s...

Hello All,Pls kindly check the attached document, is a solution we want to give to a customer kindly look at it for us if it will work.Thank u

Hi,I'm transmitting frames between 2 electronic board via a 3560-E switch. Each board is made with FPGA and broadcom ethernet chip. Frames are raw ethernet. I observed transmission problems for switch to board communication. I did some experiences: ...

Hi folks,I am working on setting up VMPS on some switches. In the VMPS database configuration file, I know I can configure a "default vlan" through VMPS fallback. Is it possible to give the different ports the different default vlans? Such as config...

I have a 3560 switch connected to a 6506 switch using a port channel of 2 GB. Everything appears to be configured and working correctly, however, when I do a show interface on the po interface, it shows a very large number of input and output queue d...

What this command does under the interface vlan 159mls rp vtp-domain TEST mls rp ipmany 10xs

Hello,I am trying to get MSTP working between Foundry SuperX and Cisco Catalyst 3560 switch. I have configured the regions and vlan mappings the same on both switches, but for some reason Cisco shows dispute on " sh spann mstp int gi0/47 det"Can anyo...