Switching

Hi All,I Have configured broadcast storm control on my switches .I want to check this configuration so how woul'd i check this.Is there any utility to flood the broadcast traffic so that i can ceck the config.

Does a mac address for serial interface exist? If so, how can i look for it in a router?I believe Serial operates at the Layer 2.

People,How to configure load balance with two link serial into same router?This links go out for internet.Thanks

Need to reset a password for Cisco catalyst 4507R switche....Help me out in this,,,Its very urgetn..Amar.

I would like to monitor a multicast group on a VLAN. I have a snoop machine connected to an access-port on the VLAN. At the moment I can see the broadcasts, some non-IP 224.0.0.0/24 multicasts, and the occasional flooded unicast packet.What I would...

Hi,I have some serious issues using HSRP msec timers. I tried HSRP, HRSP v2 and GLBP ; all the same resultsActual : IOS 12.2(33)SXHOld : IOS 12.2(18)SXF8No physical problems, no errors on the interfaces, no STP problems (no redundant links) I tried...

Advice on a problem please:Currently have a 3560 POE with 10 Mitel phones attached and RPS675 suppies the power when an outage occurs.If during an outage we try to add additional phones to the 3560 they do not power up? Any reason as to why adding ad...

Hello all,I have a wireless network connected to an Ethernet Interface of a 3660 router. The wireless network has about 300 devices (switches, AP's, Subscribers) and these devices are spread over multiple subnets. These different subnets are assign...

Hi everybody,We 've tried to configure dhcp-static on a router.When we use type "id" with client identifier, it works.But when we use type "1" with mac-address, pc can't get ip address.Could someone help, please?

Is the VTP Domain name, case sensitive?

Hi,Can any one please let me know what is Reverse path forwarding and what is the function of Upstream path and down stream path.Thanks,Akber Mirza.

We have a VTP domain with one master switch connected to several downstream switches. The domain has vtp pruning enabled.One switch wrongly prunes back vlans from the trunk which are active on the switch.I am having trouble finding an in-depth explai...

I have a client that want put the address 10.x.x.x in the vlan1 in a ce500.How can I avoid this restriction in the ce500.