Switching

Discuss Catalyst brand switches with peers and experts.
cancel
Showing results for 
Search instead for 
Did you mean: 
cancel

Labels

Forum Posts

Hi AllWe have ordered a Cisco 2610XM with 2 line cards with 16ports. The intention is to connect all our switches and routers to the Cisco 2610XM so that we can remote console to each of them. Please how can I go about configuring for terminal servic...

londint by Level 1
  • 507 Views
  • 2 replies
  • 0 Helpful votes

Hi All,Attached is the network diagram we prepared in our lab which is simulating one of our clients network setup. In the above diagram I issued default-information originate command in two routers (ROUTER-01 and SWITCH-01). I am getting one default...

ninan1306 by Level 1
  • 773 Views
  • 3 replies
  • 0 Helpful votes

Is it it possible to use Cisco 3750-E switch in distribution layer that has a function of OSPF(RIP) routing function and inter VLAN as routings of almost 5 vlans in the network and STP Protocol function enabled in distribution layer of the middle si...

habarya by Level 1
  • 1585 Views
  • 9 replies
  • 0 Helpful votes

Good dayI would like to know if it is possible to add more output requirements when doing i.e. a show run command - "show run | incl ip route". for example - show run | incl aaa <and> ip route.Is this possible?Thanks

htaljaard by Level 1
  • 825 Views
  • 5 replies
  • 0 Helpful votes

Hello !!We have decided to run the central firewall for our customers using VRF. So below I have posted the VRF config for one company, this config is on our PPPoE Router.Our PPPoE Router is connected to an Cisco ASA 5540, and the ASA nat`s the custo...

ok,Here goes. Hope you can visualize this. We have 2 6513's interconnected and setup with VLANs on both (1/2 the hosts in vlan 100 are on SW1 the other half on SW2). there's a total of 5 VLAN spread out this way. We use HSRP within the 2 switches in ...

npereira by Level 1
  • 2513 Views
  • 5 replies
  • 0 Helpful votes

Resolved! Ethernet card

Hi all,I need an ethernet card with 2 portswe have the card with 1 port WIC-1ENET=If there is a card with 2 port let me have the part numberNote: I do not need a switchport. I neet ethernet port.ThanksEric

Resolved! 6506 EtherChannel

I have two Cat 6506 with 2 1000Basex Gbic blades each in slots 2 & 3. Can you form an Etherchannel group with ports on different blades i.e. ports 2/16 & 3/16?Running CatOS 8.3(3).

j.lipsett by Level 1
  • 645 Views
  • 4 replies
  • 0 Helpful votes

Resolved! Load Balance

In 12.3T Cisco increased the number of BGP equal path links from 6 to 16. Does any one knows if they increased for the OSPF and static routes as well. Is there any supporting document on Cisco web sites?Thanks in advance..

cnuvo by Level 1
  • 694 Views
  • 3 replies
  • 0 Helpful votes