Switching

Hi!on 4507r,2 sup:sup-wsx4515;i need to configure the RPR Mode;do i need to put the console into sup on slot 2 and configure the redandany mode(rpr) or it is done in the 1st sup on the slot 1 if all config its done form there.10xs

Dear sir,My customer is having 2 isps one is from B.T(british telecom)&Primushe wants to terminate these 2 isps in one router and he wants isp failover.and primus he was having 2mbps out of this 2mb he want to segrigate 1 mbfor data and 1 mb for voic...

hello i have problem with our CORE SWITCH 4006 we reset to factory default, and it was now not running the IOS..what should i do?

Would a Catalyst 4506 chassis with Supervisor II Plus with IP Base be enough for core switch for this network or should I choose the Supervisor V or upgrade to a 6504-E?The network will consist of two core switches, each with redundant paths to 10 di...

Hi all,Is there any feature like "Web-Based Proxy Authentication" in catalyst 6500 run IOS?I saw that in Catalyst 6500 running CatOS but in IOS. Can anyone show me the similar feature in IOS.Thanks in advance,Phuong@

I have this PIX501 box and this is what I want to do: Outside: connect it to a DSL modem (yahoo/ATT SpeedStream 5100). Use DHCP Inside: connect to one or two PCs. Use static IP. The PIX box's inside IP: 192.168.1.1 The Yahoo's DNS server IP: 192.168....

I have 2 1900's f0/26 & f0/27 "suspended no link-beat" the led's don't come on, have entered trunk on. I get this if I'm connecting to the other 1900 or aui of a 2500

Is it possible for a Catalyst 6500 series switch to generate snmp traps upon the generation of interface errors (e.g. CRC, underrun)?

Hi,I am configuring a Layer 3 switch and the configuration will be similar to our Cat2948G. While setting up the access-lists I came across this statement.access-list 110 permit ip any any precedence criticalwhich goes with priority-list 1 protocol i...

Dear All,I have Cisco 1841 Router with e ports - fa0/0 and 0/1. 0/0 is configured for vlan trunking and 4 subnets are configured.default gateway for router is inside IP of Pix 506 e 6.3(4). The IP details are below.Fa0/0 - 192.168.165.910.1 - 192.168...

I need to know if the IOS Firewall processes traffic in hardware or software. I would like to take advantage of the feature, but don't want it to have an impact on performance. Oh, and right now we can't justify the $ for FWSM modules.Thanks.

Got a cisco 831 and I need to know if this router is capable of doing the pppoe auth without having the ATM interface. Currently my dsl modem is in bridge mode with a wrt54g doing the pppoe login/auth. TIA

I am running RIP and currently redistributing only the default route using the "default-info originate" command. This router also has two "types" static routes. I use static routes using the simple ip route command and I also have static routes tha...

We are trying to monitor all of our VOIP traffic and have been running into some issues so I'm in need of some help. In our current environment, we have a whole bunch of Cisco IP phones that are connected to both Cisco 3560, and 2950 switches. The ...

Hello everyone,Well I am back, I was able to flash the IOS and I am able to access configuration. Now the issue is that I am trying to access the GUI, so I can configure the settings. The IP address the IPSU (thank you cisco) gives me the ip addres...