Switching

Hi all, when I have an internet connection, and site to site vpn, how do i stop the traffic getting natted when it goes through the tunnel but not the internet?

Hi,I have a 6509 with SUP1A. I want to insert one more gig module WS-X6148A-GE-TX. Do i need a restart after inserting or will it get recognized with restarting the switch.Regards,K

Hi all, when I want to make sure that a problem is the server, not the network, do I monitor the repsonse time to the server againts the network, or do you monitor the application somehow? whats the best tool foor this ?cheers

I have got the 6506 with the two sup720 in slot 5 and 6.Whenever i remove the active sup720 from the slot 5, the switch gets booted up then the standby comes on line which takes lot of time, do i need to do any spesicif configuration to make the stan...

The following is the Gateway Router external interface counters::::stEthernet0/1 is up, line protocol is upHardware is Gt96k FE, address is 0013.c3c2.6c8b (bia 0013.c3c2.6c8b)Description: INTERFACE TO CHN_TVM LINKInternet address is 10.0.0.2/30MTU 15...

I have a number of Catalyst 65xx switches running CATOS. The default logging level (5) generates the following types of messages when a connected host powers up and down:2007 Feb 19 13:42:36 AKST -09:00 %ETHC-5-PORTFROMSTP:Port 3/45 left bridge port...

Can someone please clarify for me.If you are part of a vlan and someone on that same vlan installs a packet sniffer, will he be able to see traffic other users on the vlan are sending ?I know about SPAN and how it works but please clarify the above f...

a CCIE i use for consulting was discussing our plans to replace five 3548 XLs. We were thinking to go all gig. He explained that the PCI bus of a PC would not actually allow more than 200Mb of throughput. Is this legitmate? If so i would question the...

I'm getting a lot of late collisions on the WAN side of my router (Cisco 2801.) In the log I am also seeing errors every few minutes where that interface will come back up. I am having throughput issues with this router and I think this may be a dupl...

Hello,I am trying to create a vlan on a 6509.cc_6509_02(vlan)#vlan 1082 name ABCIt doesn't seem to like a number over 1009. I know you can create vlans up to 4096. I tried to create it from the config t prompt using vlan 1082 name ABC and this see...

Does anyone have solid documentation that an 1811 Security Router can be configured as a GRE tunnel headend device? I've yet to locate a definite 'yes' in the documentation I have.Thanks,Marc

I have 3 2950's with GBICs. I want to connect 2 of the 3 back to my 2 core switches via gigabit, but also need to have all 3 connected, preferably by GBIC. I'm using SM/LH back to the Cores. I want to be sure I don't create a loop when connecting ...

how do i configure subinterfaces in NME-16ES-1G module, as i need to have dot1q encapsulation configured on the subinterfaces. I am not able to configure subinterfaces on the fastethernet interface.Kindly let me know how can i do it.Thanks

how do i configure subinterfaces in NME-16ES-1G module, as i need to have dot1q encapsulation configured on the subinterfaces. I am not able to configure subinterfaces on the fastethernet interface.Kindly let me know how can i do it.Thanks