Switching

Hi, I have two 6509E and I want to configure it as both active. I want to load balance the traffic on my network between this two switch. I have Sup720-3B. Can anyone help? Do I need to have an IOS SLB?Thank you.

Hello,I'm looking for a method to set different MAC-Addresses for 2 VLANs on a Cisco 876 Router. The simple Way to set up the MAC-Address in the FastEthernet interface doesn't work. The New MAC-Address can be found on all VLAN Interfaces :(who can he...

HiI'm trying to find where my routing is going wrong. To understand it I'm trying to use the debug command, although I'm having no luck. I'm looking for packets from 10.222.6.36 to 192.168.16.21. Can someone please show me how to do this?ThanksDan

What is the best/common practice L2 or L3 connection between 2 distribution switches?

Hi flash:c870-advipservicesk9-mz.124-6.T2.binI'm having real trouble getting a working configuration on a Cisco 877 that is to be used for sharing an ADSL connection between two small offices.The offices will use seperate vlans, 192.168.31.0/24 (vlan...

We have a typical problem creeping up very frequently. In our campus there are some unmanaged netgear switches kept in conference rooms or at some users' cubicles. Sometimes the users before leaving the conference rooms, connect a cable back to back ...

What does this mean?"subscriber policy recording rules limit 64"I can only find the "subscriber-policy" keyword, but not subscriber. Where can I find the command guide?Thanks and Regards,Sarah

HiI've toying with idea of removing STP, as I was told its quite slow. I was advised to move towards a routing architecture. Could someone please explaing how this could be done without a core switch?I've purchased a couple of switches - although I h...

There a Checkpoint FW connected to a Cat3550 Switch using a Quad NIC. This was ok.I have just moved the connection to a Cat 4006 and it has immedaitely come up with 2006 Oct 12 14:46:36 BST +01:00 %SYS-4-P2_WARN: 1/Host xx:xx:xx:xx:xx:xx is flapping...

If im pinging the multicast IP address 224.0.0.1 from my machine what will be my reply.

hi everyone, can you help out a newbie? I'm implementing 802.1x auth on my 2950's and all is working fine. However, when I try this out on a 3524 the commands are not supported. The 3524 is running IOS 12.0 (5) Is this an IOS thing? or is the 3500 se...

Can anyone tell me the easy way of doing this and if its possible ?cheersCarl

Hi all, Is there an IOS that will allow me to create a vpn on my cisco soho 800 router ?

Can we build an etherchannel between the 2 ethernet ports of the router and a switch. can anyone post the configs required

I have a problem with overruns on my Portchannel to a VMWare ESX-Server. Does anybody has an idea from what this can come? I had pauseoutputs on another interface, and since i activated Flowcontrol, its good. I tried this here too, but still sameHard...