Hello All,We are unable to reset our switch to the factory settings. Its a new switch out off the box that we configured (attempted to configure) and hosed it up. The factory default password isn't working user ID cisco and PW using the system SN. ...
Forum Posts
Hi. I recently attempted to update 2x C9500 in SVL via DNAC from 17.6.4 to 17.9.4. It initally looked to be progressing all ok with being distributed then activated on each unit. DNAC then stated process had failed. I manually checked switches via CL...
Trying to authenticate I have this error as shown, can anyone help me!*May 11 12:38:20.482: %RADIUS-4-RADIUS_DEAD: RADIUS server 192.168.100.3:1812,18 13 is not responding.*May 11 12:38:20.482: %RADIUS-4-RADIUS_ALIVE: RADIUS server 192.168.100.3:1812...
Hi, I'm trying to prefer R2 route for the multicast traffic (without using static mroute) from R1 (receiver) to R4 (source):Receiver (R1): 10.10.10.10Source~(R4): 10.0.45.5I'm completely new to multicast and still trying to understand how it works b...
We have several remote locations with their own L3 switch that we use for routing. Some have direct fiber to our central core others uplink via another router and use VPN to tunnel back to our central office firewall.Edge switches at these locations ...
Hello, I've upgraded my Catalyst to the latest firmware avaliable. But after that the webpage stopped working and I see this Javascript error when trying to see "Port Status" or other pages. Do I need to configure something for this to work? Switch...
Hi, i have problem of synced betewin my 2 switchs nexus 7.0.3.i7.3I use feature BGP, LACP and VRRP (also VPC etc..)But it's impossible of configure correctly the protocolI have many errors :One : In log :%ETHPORT-3-IF_ERROR_VLANS_SUSPENDED: VLANs 9-1...
I have a couple of switches that are trunked via a LAN cable from another switch. I noticed that these switches sometimes have a hard time to SSH into. I get the error: "Connection timed out". After a while and a few tries I can connect just fine. I ...
Hi all, Does anyone know if there are any intermediary updates that are required to move from 15.2.2E6 to 15.2.7E2 on a 2960x? Thanks! Ian
Work on a Mac for my lab exercise, I have followed all the instructions for an SSH connection, including configuring line VTY 0 4I have read all the posts on here and nothing seems to fix the error" connection closed by foreign host".
hi all,Thanks for your reply!physical topology is very simple: core switch stack (2x WS-C6506-E) connects to access switch via port-channel, no more redundant link. I see lots of topology change logged from core switch, for example:Number of topology...
Hi AllI've inherited a newtwork that includes the C3850 and we've installed the C2960X. These are hooked up via copper ethernet and have a very simple configurationC3850 interface GigabitEthernet2/0/2 description Uplink to C2960X switchport mode tr...
When I connect to the switch(2960x) for the first time with the console, I get the following error and I cannot enter any commandError opening tftp://IP/ios name.bin (Time outThank you for helping me
Hi all, I have a cbs350-8p-e-2g with version 3.4.0.17, every time to reload it will show below message but I didn't make any configuration changes. Is it a bug ?"You haven't saved your changes. Are you sure you want to continue ?"
