Switching

Hi, i have a pair of nexus 5548 with a pair of nexus 2232 configured in active-active mode (each n2k are connected to each n5k with  2 interfaces port-channel)so my question is that, the interface configuration of fex interfaces are not synced? so if...

HelloI have a Problem with one of my CBS220 switches. I have a non redundant topology. One of my Links GE49 goes down but some times for  1-4min. Can the problem be because of al loop on GE3?How do you interpret it? Where you would start to searchLog...

Today I was upgrading remotely a 9300 IOS XE but suddenly while I was waiting after the command: install add file flags:file active commit There it was a disconnection for 1 minute with the ssh session and the Switch didn’t display the wizard again. ...

Hello ,  we are using Cisco Catalyst 9300 as below in install mode and we have  completely classical routing features etc.   As we want to upgrade on Cisco Portal we have no more IOS Image  with same Bengaluru series. I believe now we  have option to...

Hi,I'm having the same problem where the switch is not delivering the correct power wattage for IP cameras.When the PTZ camera connected to C1300, switch is delivered 8 watts onlyWhen Fixed camera connected to C1300, switch is delivered 3 watts onlyW...

Hello,if I attach the below acls I get slow throughput and high cpu on a sup2t with ios 15.2. If I copy a file with scp from 172.22.91.41 to 172.22.152.x with the acls attached I get 4.4MB/s and without the acls 111.7MB/s. What's wrong with the acls ...

Anyone willing to assist,Been trying to upgrade the IOS for a WS-C3850-48T via USB and I'm getting this error "%IOSXE-3-PLATFORM: SWITCH 1 TO R/0 KERNEL: SCSI 1:0:0:0 REJECTING TO OFFLINE/DEAD DEVICE".  After this error message my usb device is then ...

Hi,I have checked the https://tmgmatrix.cisco.com/ website and GLC-FE-100LX or GLC-GE-100LX SFP models are not compatible with  C9300-NM-8X expansion modules.Has anybody tried these SFPs models on this expansion module before?My only alternatives is ...

Hello,I have a Cisco 3850 switch. After upgrading its IOS from version 03.07.05E to 16.12.13, the device no longer recognizes the usbflash:Could you please advise on how to resolve this issue?

Please note I am having the below logs on my Nexus9K %TAHUSD-SLOT1-4-BUFFER_THRESHOLD_EXCEEDED: Module 1 Instance 0 Pool-group buffer 90 percent threshold is exceeded! cisco Nexus9000 93180YC-EXNXOS: version 9.3(2)